HBF Furniture D1013-0001-00 User manual

GENERAL NOTES
1. ALWAYS PROTECT THE WORKSURFACE DURING INSTALLATION.
2. ALWAYS LEVEL UNIT(S) AT FINAL LOCATION.
3. TWO PERSON ASSEMBLY REQUIRED
D1013-0001-00
PAGE 1
ASSEMBLY INSTRUCTIONS
LINEA CONFERENCE TABLE
HBF
HARDWARE
1 INSTALL GLIDES
2 ATTACH WIRE MANAGEMENT CLIPS
-THREAD IN ALL ADJUSTABLE GLIDES (A)
INTO BASE GLIDE HOLES
-SLIDE EQUAL NUMBER OF WIRE MANAGERS (B)
INTO THE INSIDE OF EACH SUPPORT RAIL
1/4 20 JOINT
CONNECTOR BOLT
3/4" FLAT PAN
HEAD WOOD SCREW
THUMB SCREW
1 1/8 GLIDE JOINT CONNECTOR
NOTE: LEAVE SOME OF THE GLIDE EXPOSED
BELOW BOTTOM OF BASE FOR FINAL ADJUSTMENT
DETAIL A
DETAIL B
SPLINE
A
B
CDEF
WIRE MANAGER
G
3/4" PAN HEAD
WOOD SCREW
H
SEE DETAIL A
SEE DETAIL B

D1013-0001-00
PAGE 2
LINEA CONFERENCE TABLE
HBF
4 INSTALL SPLINES
5 ALIGN AND SECURE WORKSURFACE
-INSTALL ONE JOINT CONNECTOR (E) ON EACH END OF
JOINT TO ENSURE PROPER ALIGNMENT
-INSTALL REMAINING JOINT CONNECTORS
NOTE: TOP WILL HAVE TO BE MOVED FROM SIDE TO SIDE
SLIGHTLY IN ORDER TO INSTALL ALL JOINT CONNECTORS
-INSERT SPLINES (D) IN ONE GROOVE OF EACH JOINT
-PLACE TOPS ON THE BASES IN FINAL LOCATION
-SLIDE TOPS TOGETHER ALIGNING THE SPLINES
TO THE GROOVE
DETAIL D
3 ALIGN AND ATTACH SUPPORT RAILS
-ALIGN TWO RAILS WITH MOUNTING HOLES IN SIDES OF BASE
-SECURE TIGHTLY FROM INSIDE BASE WITH CONNECTOR BOLTS (C)
-MAKE SURE TO PROPERLY ALIGN THE ALUMINUM EXTRUSIONS TO FULLY CLOSE GAPS
-REPEAT THIS PROCESS TO SECURE REMAINING RAIL ENDS TO BASES
DETAIL C
SPLINE
NOTE:
DO NOT LIFT TOP ONCE JOINT FASTENERS ARE
INSTALLED. UNEVEN LIFTING WILL PINCH THE
TOP VENEER AT THE SEAM CAUSING A BUBBLE
IN THE VENEER.
NOTE: ALWAYS INSTALL THE TOP RIGHT
SIDE UP ON TOP OF THE BASES. USE
SAWHORSES IF NECESSARY TO SUPPORT
THE TOP BEFORE THE BASES ARE ATTACHED.
SEE DETAIL C
SEE DETAIL D
GROOVE

D1013-0001-00
PAGE 3
LINEA CONFERENCE TABLE
HBF
7 SECURE RAILS TO WORKSURFACE
8 INSTALL BOTTOM PANEL
(FOR WIRE MANAGEMENT)
-SECURE BOTTOM PANEL TO UNDERSIDE
OF THE SIDE RAILS USING THUMB SCREW (H) DETAIL G
-SECURE RAILS TO WORKSURFACE USING
THE MOUNTING HOLES IN THE RAILS
WITH 3/4" SCREWS (G)
-DO THIS FOR ALL RAILS
DETAIL F
8 ADJUST GLIDES
TO LEVEL TABLE
6 SECURE WORKSURFACE TO BASES
-CENTER TOP ON BASES
-ALIGN LOCATION HOLES ON BOTTOM
OF WORKSURFACE TO OUTER SCREW
HOLE IN THE BASE FLAT PLATES
-INSTALL ONE 3/4" SCREW (F) IN EACH
CORNER TO ENSURE PROPER
ALIGNMENT
-ONCE ALIGNED, FINISH SECURING
FLAT PLATES TO WORKSURFACE
DETAIL E
SEE DETAIL G
SEE DETAIL F
SCALE 0.037
SEE DETAIL E