Impact Acoustics Focus User manual

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 211005
1/6
Focus
Acoustic Lighting
technical changes, errors and colour variations are reserved
assembly instructions

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 211005
2/6
Focus
technical changes, errors and colour variations are reserved
assembly instructions
1.
Assemble the four frame elements as
shown.
2.
Center the frame and screw it on with
the screws provided. Make sure that
the screws are only lightly tightened.
3.
Insert the light units into the panel.
4.
Connect the light inserts as shown on
the following page.

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 211005
3/6
Focus
4x
technical changes, errors and colour variations are reserved
assembly instructions
4a.
Loosen the screws of the lamp housing and
remove it.
4b.
Attention! Turn off power
before installation!
Lead the cable through the strain relief and
connect it to the cable clamp.
4c.
Tighten the strain relief.
For the Focus 2400 x 1800, one wire is
looped from one luminaire insert to the
other.
4d.
Replace the lamp housing and tighten the
screws.

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 211005
4/6
Focus
1800
2400
1540 130130
450
450 1900
1800
1800
340 1120 340
130 1540 130
technical changes, errors and colour variations are reserved
assembly instructions
suspension position
suspension position

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 211005
5/6
Focus
A
C
D
B
technical changes, errors and colour variations are reserved
assembly instructions
The screws for ceiling
mounting are not
included.
5.
Mount the suspension kits (A, B, C) to the ceiling using
suitable.
6.
Fix the hook gripper (D) to the wire rope.
7.
Hang the luminaire on the hangers.
8.
The wire ropes can be shortened, but they should
but should protrude at least 30 mm.

IMPACT ACOUSTIC AG, Bodenhof 4, 6014 Lucerne, Switzerland, 211005
6/6
Focus
technical changes, errors and colour variations are reserved
assembly instructions
9.
Mount the baldachin to the ceiling.
10.
Attention! Turn off power
before installation!
Connect the supply line to the connector.
11.
Guide the cable of the Focus light inserts
through the strain relief and tighten it.
12.
Insert the ground cable into the cable clamp
and tighten the baldachin.
• Installation and commissioning only through authorised qualified personnel.
• Modifications or overhauling to luminaires or lighting components only with the written consent of Impact Acoustic.
• The light source contained in this luminaire shall only be replaced by the manufacturer or his agent or a similarly
qualified person.
• Turn off power before working.
• Power connection only through the build-in resp. enclosed clamps.
• Luminaires and illuminants may not be disposed of as household waste. They have to be submitted to the default
local recycling process.
• It is very important to use the glover provided while mounting the light fixture