HealthyLine HEAT+PEMF User manual

iInformation
Please allow up to 40 minutes for the surface to reach
the maximum temperature.
Once flashing temperature has stopped, the indicator
displays the actual temperature measured at the core
of the Mat.
Press and hold or toreachdesirednumbersfaster.
Default PEMF frequency is set to 7.83 Hz and displayed
as 8 Hz.
FACTORY RESET
WITH THE CONTROLLER ON
The controller will shut
downand turn back ON
automatically
Press and
Hold for 10 sec
To turn PEMF OFF
PEMF
Press and Hold for 6 sec
Press PEMF button once to turn PEMF ON. Press PEMF again to initiate
PEMF frequency adjustment mode (PEMF indicator will start flashing).
Set the desired frequency (1-30 Hz) and press PEMF button again to save
the setting.
PEMF
SET and ADJUST
PEMF PEMF PEMF
TIME TIME
TIMER
SET and ADJUST
Press TIME button to initiate time adjustment mode (time indicator
will start flashing). Set the desired time and press TIME button again to
save the setting.
To switch between
Fahrenheit and Celsius
TIME
Press and
Hold for 6 sec
°For °C
UNITS SET
TEMP TEMP TEMP
TEMPERATURE
SET and ADJUST
Press TEMP button once to turn Heat ON. Press TEMP again to initiate
temperature adjustment mode (temperature indicator will start flashing).
Set the desired temperature and press TEMP again to save the setting.
POWER
Press the Power button to turn ON the controller.
TEMP, TIMER, PEMF, PHOTON indicators will light up
on the screen.
HEAT + PEMF (1 - 30 Hz)
CONTROLLER
INSTRUCTION MANUAL

GEMSTONE
HEAT THERAPY
H
ealthyLine is the leading innovator in gemstone
heat therapy technology. Continuously striving to
improve our model range altogether we oer more
than100modelswithvarioussizes,voltageandfunctions.
Therefore, we have more than a dozen dierent controller
types, specically designed for particular models.
However, controllers of dierent types may not
substitute each other even if they t in the jack.
The controller is subject to change depending
on the updates made to the product. For more
information about controllers please visit healthyline.
com/controllers.
70
65
60
55
50
45
40
35
30
25
158
149
140
131
122
113
104
95
86
77
Good for 30-90 min cycles. Temporary relief of joint pain,
stiness and minor muscle pain; provides muscular rela-
xation and a temporary increase in local circulation where
applied. Not too warm for the average person. A twice a day
limit is recommended.
130ºF - 150ºF | 30-90 MIN
Good for 30-60 min cycles. Provides the eect of an far infrared
sauna when heat is captured by a mylar blanket. When you relax
in the gentle far infrared heat, the body works hard, producing
sweat, temporarily improving circulation and recovering faster.
Once a day limit is recommended.
150ºF - 160ºF | 30-60 MIN
Good for prolonged and overnight use. Promote better
sleep and both mind and muscular relaxation. Safe setting
for those who have sensitivity to heat.
95ºF - 105ºF | OVERNIGHT
Good for cycles of 2 hours or less. Temporary relief of joint
pain, stiness and minor muscle pain; provides muscular
relaxation and a temporary increase in local circulation where
applied. Not too warm for the average person.
105ºF - 130ºF | OVER 2 HR
Please note that you always get the right controller for your mat.
Cover the mat to retain heat and reach desired temperature
faster.
Please do not switch controllers between dierent mats.
Drink plenty of water before, during, and after use.
The higher the temperature setting, the shorter the session
should be.
Do not use PEMF or high heat settings while pregnant.
Do not use PEMF or high heat settings if you have metal
implants or a pacemaker.
Do not use if you have varicose veins.
Do not use with muscle relaxants.
Please consult with your doctor if you have any serious
medical condition before using this or any medical device.
WARNINGS
!
INFORMATION
!