Hearth and Home Technologies IntelliFire IFT-RC150 User manual

1
Hearth & Home Technologies • RC150 User Guide • 2326-981 Rev. B • 10/16
User Guide
IFT-RC150
IntelliFire™ Touch Wireless Wall Switch
Introduction
The IFT-RC150 is a wall-mounted wireless wall switch
that is designed to operate Hearth & Home Technologies
appliances equipped with the IntelliFire™ Touch
Technology. It can be used to control the ON/OFF and
cold-climate function of your appliance. This user guide
serves as a quick reference to the wall switch operation.
Operation
Flame ON/OFF
• To turn the ame ON, press the top of the rocker switch.
• To turn the ame OFF, press the bottom of the rocker
switch.
The appliance has a safety feature that automatically
shuts down the appliance after 9 hours of continuous
operation.
Cold Climate
This function turns on a continuous pilot and keeps the air
inside the appliance warm while not in use. It is a useful
feature in cold weather to minimize condensation on the
appliance glass.
• To turn the cold climate mode ON/OFF, press the small
momentary push button below the rocker switch.
Note: This feature is disabled when a Power Vent is
installed on the appliance.
LED Indicator
• The LED indicator is located above the rocker switch. It
blinks every time it transmits a command.
• The LED also functions as a low battery indicator.
Replace batteries if the red LED blinks once every 3
seconds continuously for longer than 5 minutes.
Note: Batteries should only be used as an appliance power
source in the event of a power outage. Batteries
should not be used as a primary long-term power
source.
Power Outage
In the event of a power outage, the wall switch can
continue to operate the appliance if batteries are installed
in the appliance’s battery backup system. Refer to the
appliance owner’s manual for operation during a power
outage.
Figure 1. RC150 Functions
RED LED
COLD CLIMATE ON/OFF
FLAME ON
FLAME OFF

2Hearth & Home Technologies • RC150 User Guide • 2326-981 Rev. B • 10/16
Please contact your Hearth & Home Technologies
dealer with any questions or concerns.
For the location of your nearest
Hearth & Home Technologies dealer,
please visit www.hearthnhome.com.
This equipment complies with part 15 of FCC RF Rules. Op-
eration is subject to the following two conditions:
1) This device may not cause interference and
2) This device may accept any interference, including interfer-
ence that may cause undesired operation of the device.
CAUTION! Risk of burns! Appliance surfaces are hot
when operating and during cool down. Use care and wear
gloves when opening the front and accessing compo-
nents inside the appliance.
Turn off power to the appliance (if back-up batteries
are not installed):
• If the appliance comes equipped with a wired-wall switch,
use that to turn it off.
• Alternately, you can also locate the house circuit breaker
for appliance and turn it off.
Manual Fireplace Shutoff
In the unlikely event that the wall switch malfunctions and
will not turn off the replace, call your dealer for service
assistance. In the meantime, turn off your appliance by
performing the following actions:
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
Symptom Possible Cause Corrective Action
The appliance does not respond to
commands from the wireless wall switch
and the LED does not blink.
Batteries are depleted. Verify batteries are new.
Batteries are incorrectly installed. Verify batteries are installed in correct orientation
as shown on battery receptacle.
The appliance does not respond to
commands from the wireless wall switch but
the LED blinks.
The appliance does not respond to com-
mands from the wireless wall switch, but
the LED blinks the the switch is touched.
The wireless wall switch is not paired
to the control module. Call dealer for service.
The wall switch LED blinks even though no
command is given. Communicating with control module.
This is normal operation. The wireless wall
switch communicates periodically with the con-
trol module to send or receive information.
The wall switch LED blinks constantly once
every 3 seconds. Low battery indicator. Replace the batteries in the wireless wall switch with new batteries.
The appliance turns OFF the ame after
extended periods of operation. 9 hours safety shutdown timer.
This is normal operation. The appliance will au-
tomatically turn the ame OFF after nine hours
of uninterrupted operation See Section 3A.
Frequently Asked Questions/Troubleshooting