Heatpol Home + User manual

HEAT SYSTEM
GUIDE & USER MANUAL
HEATER CONTROLLER H+ WiFi |TEMPERATURE SENSOR
HEATER
CONTROLLER
–
VERTICAL
TEMPERATURE
SENSOR/
REMOTE
CONTROLLER
•
E
C
O
D
E
S
I
G
N
•
R
E
A
D
Y

SAFETY:
1. The heater should be installed by a qualied person.
2. Bathroom radiators tted with electric heaters should be xed not less than 60 cm from
a bath, shower or wash basin, and never above abath.
3. For the heater permanently connected (hard wire) there must be applied a cut-off device
from the mains. Such a device must disconnect the heater from the supply mains in
2 poles, with contact separation of at least 3 mm.
4. This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved
5. Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
6. The heater MUST BE DISCONNECTED before cleaning the casing.
AVOID SOAKING THE CASING.
7. One radiator valve must always be open when a heater is in use (liquid thermal expansion).
CAUTION: To avoid the risk of re or electric shock the heater should be protected from water spray or ooding. This
appliance is not intended for use by persons (including children) of limited physical, sensory or mental abilities, or per-
sons inexperienced or not familiar with the appliance, unless supervised or instructed on the appliance use by persons
responsible for their safety. Par ticular attention should be paid to children, to preclude playing with the appliance by them.
Exclamation mark on triangular eld signals: information important for the user.
CAUTION: electric shock hazard!, lightning mark ended with arrow on triangular eld
CAUTION:
in order to reduce electric shock hazard, do not remove the casing (nor its rear cover). There are no user-
serviceable parts inside the appliance; the product must be returned to the manufacturer for repair via the distributor who
sold the product.
GUARANTEE TERMS:
Guarantee is granted by manufacturer for 24 months period star ting from date of sale, but no longer than 36 months from
date of the heater manufacture. Defects revealed within this period, resulting from a fault of manufacturer will be repaired
free of charge or the item replaced with new, equivalent one. Term of complaints’ investigation up to 14 (fourteen) days
from date of submission to the manufacturer.
Guarantee does not cover:
1. Using of product in a manner noncompliant with attached instructions.
2. Any visible damage to the heating element or controller due to improper use. Damaging of manufacturer’s seals makes
the guarantee null and void.
In the event that Heatpol are unable to repair or replace this product we reserve the right to refund the purchase price
as an alternative.
GUARANTEE CARD
Serial No.:
Date of sale:
Stamp of retail outlet, signature of seller
Caution: The guarantee card should be legibly lled in retail outlet. Any corrections on the guarantee card will invalidate
the guarantee. Guarantee card valid only with proof of purchase.
Mników 322, 32-084 Morawica, Poland
Tel/fax: [phone]
www.homeplus-system.com
www.homeplus-system.com
 2 ]

SAFETY:
1. The heater should be installed by a qualied person.
2. Bathroom radiators tted with electric heaters should be xed not less than 60 cm from
a bath, shower or wash basin, and never above abath.
3. For the heater permanently connected (hard wire) there must be applied a cut-off device
from the mains. Such a device must disconnect the heater from the supply mains in
2 poles, with contact separation of at least 3 mm.
4. This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved
5. Children shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
6. The heater MUST BE DISCONNECTED before cleaning the casing.
AVOID SOAKING THE CASING.
7. One radiator valve must always be open when a heater is in use (liquid thermal expansion).
CAUTION: To avoid the risk of re or electric shock the heater should be protected from water spray or ooding. This
appliance is not intended for use by persons (including children) of limited physical, sensory or mental abilities, or per-
sons inexperienced or not familiar with the appliance, unless supervised or instructed on the appliance use by persons
responsible for their safety. Par ticular attention should be paid to children, to preclude playing with the appliance by them.
Exclamation mark on triangular eld signals: information important for the user.
CAUTION: electric shock hazard!, lightning mark ended with arrow on triangular eld
CAUTION: in order to reduce electric shock hazard, do not remove the casing (nor its rear cover). There are no user-
serviceable parts inside the appliance; the product must be returned to the manufacturer for repair via the distributor who
sold the product.
GUARANTEE TERMS:
Guarantee is granted by manufacturer for 24 months period star ting from date of sale, but no longer than 36 months from
date of the heater manufacture. Defects revealed within this period, resulting from a fault of manufacturer will be repaired
free of charge or the item replaced with new, equivalent one. Term of complaints’ investigation up to 14 (fourteen) days
from date of submission to the manufacturer.
Guarantee does not cover:
1. Using of product in a manner noncompliant with attached instructions.
2. Any visible damage to the heating element or controller due to improper use. Damaging of manufacturer’s seals makes
the guarantee null and void.
In the event that Heatpol are unable to repair or replace this product we reserve the right to refund the purchase price
as an alternative.
GUARANTEE CARD
Serial No.:
Date of sale:
Stamp of retail outlet, signature of seller
Caution: The guarantee card should be legibly lled in retail outlet. Any corrections on the guarantee card will invalidate
the guarantee. Guarantee card valid only with proof of purchase.
Mników 322, 32-084 Morawica, Poland
Tel/fax: [phone]
www.homeplus-system.com
[ 3 ]
Kit content
USER MANUAL: Heating element + Heater controller (vertical) H+
1
Heating
element
Heater
controller
O/D shaped
color cover Allen
key
Wall mount
plastic cover
+
_
System option:
Temperature sensor
Preparing the temperature sensor
Locate suitable place to mount temperature sensor
2
3
Pairing button
for allen key (F)
Back
Magnet clip Wall clip mounting
To activate temperature sensor
for the rst time, press the pairing button
LED (Activity)
Do not place the temperature sensor:
– over the radiators
– next to doors
– in sunny places

 4 ]
Mounting in radiators
USER MANUAL: Heating element + Heater controller (vertical) H+
>60cm>60cm
Installation options: central heating system Installation options:
electric radiator
T-piece installed with
locshield valve
central connection one-pipe valve
connection
T-piece connection
with locshield valve
Installation details
S24 S24
230 V
1 2
Do not play in yet
Line up dot at front
Central heating system

[ 5 ]
4
3
5
3-5cm
6A 7
Electric radiators
S22 S22
leave space
Finishing
?
?
?
8
Central heating system
6B
Cut to length
Element (D) must be cut
the correct lenght
Hard wire connection
For the heater perma-
nently connected (hard
wire) there must be
applied a cut-off device
from the mains. Such
a device must discon-
nect the heater from the
supply mains in 2 poles,
with contact separation
of at least 3 mm from
the main supply
9A
230 V
Connection with a coiled
cable and a plug
Live
Earth
Neutral
ON/OFF
Przełącznik
9A
230 V
After electric connection, turn on the switch
(concern only hard wire connection)
10

 6 ]
USER MANUAL: WiFi conguration
Heater controller display
When the heater is connected to
the mains properly, the red light
will ash on the controller display
Heater controller
1
The heater is ready for WiFi conguration
2
Go to supla.org and create a free supla account and follow the attached instructions.
3
DOWNLOAD THE APP
QR CODE
Wygenerowano na www.qr-online.pl
SUPLA.ORG
System requirements ANDROID 3.1/IOS 8.2 or the latest version
Install the application on your devices.
The app will guide you through the individual
installation steps.
DO NOT DISCONNECT! controller from heating element, when connected to the power supply
TURBO mode activation
1
3

DO NOT DISCONNECT!
controllerfromheatingelement,whenconnected
tothepowersupply
Lack of water (or wrong choice
of heating element to the heater)
Damaged heating element
(or no power cuircit)
No communication to the remote
controller if paired
Errors
Max heating temperature, selection for 1/2/3 hours
Off selection
TURBOmodeactivation
3
sec
+
–
TURBO mode activation - max heating temperature
Hold button for 3 seconds
4
Press twice
upper and lower
button together
2x
2x
Run the heater controller
via remote controller
Hold upper button
for 3 seconds
Switch off the controller
via remote controller
Hold lower button
for 5 seconds
40˚C
Standard heating
temperature
3
sec
5
sec
2
10˚C - 65˚C*
Select temperature
+
–
3
Temperature selection.
+
–
Settingswaterorambienttemperature
The remote is
a temperature sensor
* maximum temperature can be different
according to the producer settings
Water
temperature 10-65˚C*
Ambient
temperature 10-30˚C
DO NOT DISCONNECT!
controllerfromheatingelement,whenconnected
tothepowersupply
Lack of water (or wrong choice
of heating element to the heater)
Damaged heating element
(or no power cuircit)
No communication to the remote
controller if paired
Errors
Max heating temperature, selection for 1/2/3 hours
Off selection
TURBOmodeactivation
3
sec
+
–
TURBO mode activation - max heating temperature
Hold button for 3 seconds
4
Press twice
upper and lower
button together
2x
2x
Run the heater controller
via remote controller
Hold upper button
for 3 seconds
Switch off the controller
via remote controller
Hold lower button
for 5 seconds
40˚C
Standard heating
temperature
3
sec
5
sec
2
10˚C - 65˚C*
Select temperature
+
–
3
Temperature selection.
+
–
Settingswaterorambienttemperature
The remote is
a temperature sensor
* maximum temperature can be different
according to the producer settings
Water
temperature 10-65˚C*
Ambient
temperature 10-30˚C
[ 7 ]
USER MANUAL: ERRORS
DO NOT DISCONNECT! controller from heating element, when connected to the power supply
Lack of water (or wrong choice of heat-
ing element to the heater)
Damaged heating element
(or no power cuircit)
No communication to the remote
controller if paired
ATTENTION: Signalling improper installation or improper use:
ATTENTION:
The temperature sensor can be used as a remote controller instead of your Smartphone
TURBO mode activation
12
3

 8 ]
USER MANUAL:
NEW TEMPERATURE SENSOR/REMOTE CONTROLLER PAIRING
Pairing nished!
Remote controller
is already working
Allen key
included
1x
1x
Press once
upper and lower
button together
Hold 3 sec.
Start countdown
3
sec
During countdown
within 30 seconds
Reverse remote controller.
Push pairing button!
Prepare remote controller + allen key for use
When you buy a new heating element with a remote controller it will already
be paired. You do not need to pair it again.
In case you purchase a new temperature sensor/remote controller –
you need to pai it: