HEATSTRIP CROSSRAY 2B Series User manual

1
CROSSRAY GAS KITCHEN
PRODUCT INSTALLATION
MANUAL
2B + 4B SERIES
crossray.com.au | 03 9562 3455 | [email protected]

1 Install Casters.
2
Phillips Head Screw 3/16"x3/8"
Qty.16
Install Trolley side panels.
Phillips Head Screw 3/16"x3/8"
Qty.6
Side Cabinets
2

3 Install Trolley Rear panel.
Phillips Head Screw 3/16"x3/8"
Qty.9
4
Phillips Head Screw 3/16"x3/8"
Qty.4
Rear panel,Down Rear panel,Upper
Install Door Bracket.
3

5
Double screw 3/16"x3/8"
Qty.4
1.
2.
4
Install middle panel.
Install the screws.
Slide in the midde panel.

6
Phillips Head Screw M6X20
Qty.61. Pre-install the screws partially on the underside of
the benchtop
(Do not tighten to the end).
2.
5
Install countertop.
Position the pre-installed Screws on
the cabinet（Handle with care）.
Follow the same instruction
to install the sink countertop.

7
7 finish
Install Door
6
1.Tilt the door and insert to the hole on bottom.
Tilt the door to an angle.
2.Press the latch on the door, and slide
the door into the hole when the latch is
flush with the door support piece.

1 Install Casters.
Phillips Head Screw 3/16"x3/8"
Qty.16
2
Phillips Head Screw 3/16"x3/8"
Qty.6
4B BBQ /2B BBQ cabinet
Install Trolley side panels.
7

4
3 Install Trolley Rear panel.
Phillips Head Screw 3/16"x3/8"
4B-Qty.7
2B-Qty.6
Double screw 3/16"x3/8"
Qty.2
8
Install AGA separation panel .

Phillips Head Screw 3/16"x3/8"
Qty.2
5 Install Doors
9
Install Door－please refer to P6.

10
How to attach the cabinets together？
Phillips Head Screw 3/16"x3/8"
Qty.4
Washer
Qty.4
Flange Nut3/16"
Qty.4
Washer
1.Put all cabinets together.There are 4 screws,
two through the top vents, and 2 through the
bottom vents.
2.Open the door of main cabinet, put 2
screws into the holes to fix with left cabinet as
below picture shown, insert the screw close
to the side of hole, as this is the most secure.
Phillips Head Screw
3.Apply above method to fix main cabinet
with right cabinet.