Helmholz 700-841-16S01 User manual

Helmholz GmbH & Co. KG | Hannberger Weg 2 | 91091 Großenseebach
Phone [phone] | Fax [phone] | [e-mail] | www.helmholz.de BT-beipack-169
2021-02-12
Ethernet Switch 16-port, unmanaged, 10/100/1000 Mbps
700-841-16S01
Version 2 for HW 1 or higher
Application area
The Helmholz Ethernet Switch 16-port, unmanaged is suitable for installation on a DIN rail and connects
up to 16 Ethernet participants with 10, 100 or 1000 Mbps.
Connections
The Ethernet Switch 16-port has 16 RJ45 connections. The Ethernet Switch 16-port must be supplied with
24 V DC at the 18 - 30 V wide range input via the provided connector plug. The terminal (FE, ) is for the
functional ground. Connect this correctly with the reference potential.
Features
- Store-and-Forward architecture
- 10BASE-T/100BASE-TX/1000BASE-T
- Full-/Half-Duplex
- Auto negotiation
- Auto MDI/MDI-X (IEEE 802.3u Auto crossover support)
- QoS-Priority-Queues: 8
- LLDP & PTCP Delay-Traffic blocking (for PROFINET networks)
- 2x 16K MAC address lookup table
- 2x 256 Kbyte memory for frame buffering
- Up to 51 Gbps high-performance memory bandwidth
- support Jumbo frame sizes up to 10Kbyte
LEDs
PWR Led On = Power supply present
Off = No voltage or the device is defective
RJ45 LEDs
Orange (Link/Activity): On or Blinks = Data transmission
Green (Speed): On = 1000 Mbps Blinks = 100 Mbps Off = 10 Mbps
Attention: If the device is used in a manner not specified by the manufacturer, the protection
provided by the device may be affected. Pay special attention to the correct contact during cable installation.
If you have problems, always read the latest documentation first, which can be found on the Internet at
www.helmholz.com. Connected circuits shall meet the requirements of Limited energy circuits acc. UL61010-1.

Helmholz GmbH & Co. KG | Hannberger Weg 2 | 91091 Großenseebach
Phone [phone] | Fax [phone] | [e-mail] | www.helmholz.de BT-beipack-169
2021-02-12
Technical data
Order no.
700-841-16S01
Name Ethernet Switch 16-Port, unmanaged, 10/100/1000 Mbps
for DIN rail
General information
- Scope of delivery Ethernet 16-port switch with power supply plug,
short manual
- Dimensions (DxWxH)
32,5 x 124 x 80,5 mm
- Weight
approx. 280 g
LAN interface
- Number
16
- Type 10BASE-T/100BASE-TX/1000BASE-T, Full/Half-Duplex,
Auto negotiation, Auto MDI/MDI-X
- Connection
RJ45
- Transmission rate
10/100/1000 Mbps
Status indicator
1 LEDs power display, 32 LEDs Ethernet status
Voltage supply
24 V DC (18...30 V DC)
Current draw
max. 350 mA with 24 V DC
Power loss
8,4 W
Environment requirements
- Ambient temperature
-25 °C … +75 °C
- Transport and storage
temperature
-40 °C … +85 °C
- Relative air humidity
95 % r H without condensation
- Pollution degree
2
- Protection rating
IP20
- Certifications
CE
UL
UL 61010-1/ UL 61010-2-201
- Voltage supply
DC 24 V (18 ... 30 VDC, SELV and limited energy circuit)
- Pollution degree
2
- Altitude
Up to 2000 m
- Temperature cable rating
87 °C
Note:
The contents of this document have been checked by us for matching with the hardware and software
described. However, we assume no liability for any existing differences, as these cannot be fully ruled out.
The information in this document is, however, updated on a regular basis. When using your purchased
products, please make sure to use the latest version of the document, which can be viewed and downloaded on
the Internet at www.helmholz.de.