HENRI Kelkay Leonesco User manual

H5215F5RL
Leonesco Fountain
STAGE 1
Ensure you have all the correct items
before you begin the assembly
process.
STAGE 2
Stand the pedestal upright with the
large bowl on top ensuring the large
bowl is central to the pedestal.
STAGE 3
Feed the pump cable through the hole
in the large bowl and feed all the way
through until the there is approx 10cm
of cable between the pump and the
bowl. Wrap the large rubber stopper
around the cable and force into the
hole creating a water tight seal.
STAGE 4
Stand the small pedestal inside the
large bowl encasing the pump; attach
one end of the black tubing over the
pump’s nozzle.
STAGE 5
Sit the tall pedestal on top of the small
pedestal feeding the tubing through as
you stand it up.
STAGE 6
Wrap the smaller rubber stopper
around the tubing and force down into
the hole creating a water tight seal.
1 of 2

H5215F5RL
Leonesco Fountain
STAGE 7
Feed the end of the tubing through
the top finial and stand on top of the
tall pedestal.
STAGE 8
Insert the large trap door into the open
space at the bottom of the fountain.
STAGE 9
The fountain is now ready for water,
see your users guide for filling levels.
STAGE 10
If the fountain isn’t level of for some
reason the water flows unevenly, use
‘shims’ to level up, simply slide under
the side that needs propping up and
snap off once the water level becomes
even.
2 of 2
IMPORTANT - WINTER CARE
Winter Ice build-up can cause damage to concrete statuary. Follow these tips
to reduce winter weathering to your fountain:
•Disconnect power to pumps.
• Remove adapter from bottom bowl to open drains and let all moisture
out. Keep drains open throughout winter.
• Place an absorbant material like burlap, blankets etc inside
vases/bowls and cover all with a fountain cover.
• Do not allow snow or ice to build up on or against the concrete.
Remove snow before it turns to ice. Do not use salt or chemical ice
removers as these may damage concrete.
ADVISORY NOTICE
HEAVY ITEMS!
Please take care when handling these items