Herman Miller Canvas Office Landscape Installation instructions

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b3k5c rev C.
1
Y
Parts Included:
Tools Required:
Canvas Office Landscape®Interiors Wall Strip Trim Strip
Installation and Disassembly for Recycling Instructions
Trim Strip Hardware Pack
Power Driver #39 Drill Bit #2 Phillips Bit
Truss Head
Screw (3)
AB
IMPORTANT: Save these instructions for layout changes.
Safety Glass
Note: Trim Strip is universal and can be mounted either right or left-handed

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b3k5c rev C.
2
Wall Strip
Clearance
Hole
1. Position Trim Strip (A) against Wall Strip. Lining up bottom of Trim Strip with Bottom
of Wall Strip.
2. Mark location of Clearance Holes onto Wall Strip.
3. Drill three Pilot Holes into Wall Strip.
4. Secure Trim Strip to Wall Strip with three Truss Head Screws (B).
5. Use touch-up paint matching trim color to cover screw heads.
Note: When properly installed top of Trim Strip should be 7/16” above top of Wall Strip.
A
A
B
1
Pilot Hole
Wall Strip
7/16”
Assembly Instructions:
Disassembly for Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling codes.
Use these codes to identify material type for recycling. Non marked components
should be treated as mixed plastic. Ferrous metals can be identied using a
small magnet for recycling. Non-ferrous metals should be separated and recycled
separately.
To disassemble product, reverse steps 5 through 1.