Herman Miller Canvas Vista Installation instructions

Power Driver #2 Phillips
Extended Bit
Tools Required
Parts Included
HermanMiller
Canvas Vista Suspended Storage
Installation and Disassembly for
Recycling Instructions
How to assemble Vista Suspended Storage
L2SCF – Suspended Cubby
Tapping Screw
Pan Head (6)
Tapping Screw
Pan Head (4)
Tapping Screw
Pan Head (2)
L2SDF – Suspended Drawer
Storage Guide
LSCF – Suspended Cubby
. Remove the drawer body from the cubby storage.
. With the table upside down, align cubby storage to either the front
le or right corner of the table and align the holes in the top of the
storage unit with the  locating holes in the work surface. Make sure
the cabinet is flush with the worksurface edge.
Wall with the notch faces
to the inside
This is a LH cubby - it installs on the LH side of the desk
(in the in use position)
Step 
Step 
1HermanMiller Installation Instructions1BNPF3 rev A

2HermanMiller Installation Instructions1BNPF3 rev A
. Using pre-drilled pilot holes, screw in  long # tapping screws
from provided hardware pack.
Step 
. If the cubby is installed on a height adjustable table install
the storage guide using the two # tapping screws and the
pre-drilled locating holes in the bottom of the cabinet.
” Deep Table Location
” Table Location
Step 
. Once table is flipped right side up and leveled, re-install
the drawer body. Ensure that the drawer face is aligned. If not
aligned, Loosen the screws attaching the drawer front and align.
Then tighten the screws.
Step  LSDF – Suspended Drawer
. With the table upside down, screw in  short # tapping
screws to the  locating holes in the work surface. Do not screw
them in all the way, allow enough room for them to engage with
the key hole slots in drawer storage.
Step 

3HermanMiller Installation Instructions1BNPF3 rev A
. Remove the drawer body from the drawer storage.
. Once in place with drawer storage flush to work surface edge,
tighten the  screws to the work surface through the clearance
holes in the bottom of the drawer storage.
. With the table still upside down, place the drawer storage over
the partially screwed in screws through the attachment bracket’s key
hole slots. Slide the drawer storage until it is aligned flush with the
edge of work surface.
Notched side panel toward the inside
The RH drawer is shown. It is on the RH
side of the table in the in use position.
Step 
Step 
Step 
. Once table is flipped right side up and leveled, re-install the
drawer body. Ensure that the drawer face is aligned. If not aligned,
loosen the screws attaching the drawer front and align. Then tighten
the screws.
Step 

4HermanMiller Installation Instructions1BNPF3 rev A
. If the Suspended Drawer is being installed on a height adjustable
table, install the Storage guide to the bottom of the storage unit by
aligning the guide with the locating holes in the storage unit that are
next to the leg in the table. Install the  self tapping screws.
” Deep Table Location
” Table Location
Step  Disassembly and Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling
codes. Use these codes to identify material type for recycling. Non
marked components should be treated as mixed plastic. Ferrous metals
can be identied using a small magnet for recycling. Non-ferrous metals
should be separated and recycled separately.
To disassemble product, reverse the above installation steps:
For more information about our products and services please visit us at
hermanmiller.com or call ()  .
© Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. BNPF  A