Hexagon Mobileye 6 User manual
23 May 2022 1
Mobileye 6 Quick Start Guide
Version 1 | May 2022
Mobileye 6 Quick Start Guide
The Mobileye 630 system (ROS driver available) uses a smart digital camera
located on the front windshield inside the vehicle.
Inside the camera, Mobileye’s powerful EyeQ2® Image Processing Chip provides
high-performance real-time image processing, by utilizing the Mobileye vehicle, lane
and pedestrian detection technologies to effectively measure and calculate dynamic
distances between the vehicle and road objects.
Box Contents
Main Unit
Eyewatch
Main Cable
EyeCAN Adapter
Other Equipment Needed
Laptop computer
Kvaser USB/CAN Adapter
Measuring tools for calibration (tape measure and level are recommended)
Installation
1. Mount the Mobileye to the center of the windshield.
2. Connect the Mobileye to vehicle CAN via the Mobileye 6 main cable.
3. Connect the EyeWatch to the main cable.
4. Supply 12VDC power via BAT+ and GND. A 12V ignition signal is required.
5. Connect a Windows laptop to the Mobileye via the USB EyeCAN adapter.
23 May 2022 2
Mobileye 6 Quick Start Guide
Version 1 | May 2022
Mobileye 6 wiring diagram
Communications –Setup Wizard (Configuration and Calibration)
1. Download the Setup Wizard installer here: mobileye.com/us/fleets/support
2. Though the Mobileye should be configured and calibrated using the EyeCAN adapter, the user may splice
EyeCAN and terminate it to be adapted to their own CAN bus interface.
Mobileye setup wizard
Table of contents
