highwood Pottsville User manual

ASSEMBLY GUIDE
“Pottsville” Corner Fence
TOOLS
• Heavy duty hammer
• Level
• Flathead screwdriver or pliers
• Screwdriver/Square bit #1
(Power screwdriver/Square bit #1
recommended)
• Small block of wood
COMPONENTS
Part Description Qty
(A) Side sections 2
(B) 48" Center post 1
(C) 39" End posts 2
(D) Post caps 3
(E) Metal ground stake (no dig) 3
(F) Stainless steel screws 12
Square bit #1 1
(F)
(A) (A)
(C) (C)
(B)
(D)
(E)
CNRF1 [10.11.12]

STEP 1
STEP 2
Install metal ground stake for center post
Measure and mark the half way point on Metal ground stake (E)
as shown in Figure 1 below. Place Stake (E) in desired location for
Center Post (B) and carefully use a hammer to drive it into ground.
Use level to make sure the stake is straight and plumb. Adjust as
needed and nish driving it into the ground using a small block of
wood on top of stake as shown in Figure 2 below. Install no deeper
than the half-way point.
Fig. #1 Fig. #2
STEP 3
Set ground stake tabs into place
Use a at head screwdriver and/or a set of pliers to bend the
locking tabs on Metal ground stake (E) into appropriately a
45 degree angle as shown in Figure 3 below.
Fig. #3
45˚
Before you start
IMPORTANT Check for underground services with your local authorities BEFORE installation of this product.
They will typically mark out underground cables/gas etc at no charge.
Set the fence in the desired location and carefully measure and
mark the ground where the center of each post will fall assuring that
each rail will set at a 45 degree angle as shown below.
45˚45˚

STEP 4
Attach center post to ground stake
With the ground stake in place and the locking tabs set into
position slide Center post (B) over the stake as shown in Figure 4
below.
Note: Make sure to slide the post straight down so the locking
tabs touch the inside wall and properly engage in the corners of
the highwood® post as shown in Figure 5 below.
STEP 6
STEP 5
Install metal ground stakes for end posts
Take each of the side sections (A) and hold them in the position
that they will be tted to the center post. Double check and
carefully mark the end post (C) locations on the ground. Remove
side sections and install two ground stakes (F) for End posts (C)
following Steps 2, 3, and 4.
Fig. #4 Fig. #5
Fig. #6
Final post adjustment
Final adjustment may require you to twist the post and ground
stake so the three posts are positioned in the correct direction.
This rotation adjustment will not disrupt the ground attachment of
the stake.
Note: Ensure that the corner fence will be straight and in-line
when assembled.

Visit our Website and Facebook page to see more highwood®products!
www.highwood-usa.com • www.facebook.com/highwoodUSA
Enjoy your Pottsville corner fence!
STEP 8
Attach post caps
Attach Post caps (B) to top of each post.
STEP 7
Attach side sections
Slide the two side sections of fence down and into place between
center post and end post. Use twelve screws (F) and attach side
sections using the pre-drilled holes in center post and end posts.
Highwood products are ultra-low maintenance but for
information on seasonal cleaning or to see a video that
explains how to remove minor scratches visit
http://www.highwood-usa.com/care.html
Care and Cleaning
(F)
Other Highwood items you may be interested in.