
12
3
English CORDLESS LANTERN UB18DSL HANDLING INSTRUCTIONS
806
Code No. C99157421 A
Printed in China
服务中心
工机商业(中国)有限公司
上海市闵行区浦江工业园区三鲁路3585号7幢3楼
制造商
高壹工机亚洲有限公司
香港新界荃湾青山道388号
中国染厂大厦11楼A-D室
Lamp cap
323-519
Fluorescent lamp
323-339
Lamp cover
323-340
LED
Knob
Handle
Latch
Battery
Latch
Battery
Lamp cover
Reflector
326-194
Please read the following instructions throughly before using this lantern and use it correctly.
CAUTION:
●Do not touch the fluorescent tube while lit or right after
using. Touching it might cause burns.
●When hung from a high position always secure it with
string or similar item so it won’t fall. If it falls, injuries might
result.
●Always turn the switch off(OFF) when not using or when
replacing the fluorescent lamp.
●Do not use in the rain.
●Do not disassemble, strike or otherwise apply impacts to
the lantern body.
●Do not let gasoline or thinner get on the lantern body.
●Do not leave the lantern in places that reach high
temperatures (60°C or higher) such as in vehicles under a
blazing hot sun.
Doing so might cause the lantern to break down.
●Do not use any other than the specified storage batteries.
NOTE: Do not leave the switch in the ON position while not in use. This will shorten the life (charge/discharge times) of the battery.
SPECIFICATIONS
Battery BSL1430 (sold separately) BSL1830 (sold separately)
Fluorescent lamp Compact FL9W (Code No.323339 for replacement fluorescent lamps.)
Operating time
(Using full charged 3.0 Ah Battery)
Fluorescent light Approx. 3.5 hours Approx. 5 hours
LED Approx. 150 hours Approx. 150 hours
Dimensions height 305 mm × width 95 mm × depth 96 mm (without battery)
Weight 0.5 kg (without battery)
HOW TO USE
1. Inserting or removing the battery (See Fig. 2)
To install, make it face the same as battery and insert
inwards in the direction in the figure.
To remove, extract it towards the direction while holding
down the latch of battery.
2. Replacing the fluorescent lamp (See Fig. 3)
Turn the lamp cover in the direction and remove it.
Remove the reflector and lamp cap and replace the
fluorescent lamp.
After replacing with the new lamp, install the reflector and
lamp cap and reinstall the lamp cover in the direction .
AUTOMATIC SWITCHING FUNCTION
The lamp automatically switches to the LED to prevent total
loss of light when the battery wears down.
* When the BSL1430 or BSL1830 battery is used, LED may not
be turned on due to the battery’s over discharge protection.
NOTE: Only parts 1, 2, 3and 4will need replacement.
Important notice on the batteries for the HiKOKI
cordless power tools
Please always use one of our designated genuine batteries.
We cannot guarantee the safety and performance of
our cordless power tool when used with batteries other
than these designated by us, or when the battery is
disassembled and modified (such as disassembly and
replacement of cells or other internal parts).
4
2
3
1
UB18DSLChs.indd2UB18DSLChs.indd2 2018/04/0514:02:302018/04/0514:02:30