HIRED-HAND, INC. •1733 County Road 68 •Bremen, AL 35033 •Phone 256-287-1000 •Fax 256-287-2000
Manual Part No. 4801-5108
1.
This fan should be securely mounted from
chains. Refer to mounting instructions on
reverse side of this sheet.
2.
Fan is provided with wire guards for your
protection.
National safety codes require that guards
be installed if fan is installed within 7 feet (2.1 m) of
floor or within reach of personnel or livestock.
3. IMPORTANT: Inspect fan
may obstruct blade rotation.
4.
If thermostat is used, connect fan power cord to
controller.
5. Fan is now ready for operation.
Your fan has been manufactured with the finest materials and
components available, and is backed by a one year warranty
against electrical and mechanical defect
s in material and
workmanship. If this fan fails to operate during this period,
return it prepaid to the place of purchase for repair or
replacement without charge at the manufacturer’s option.
Damage by accident or abuse is not covered by this warranty.
This warranty gives you specific legal rights and you may have
other rights that vary from state to state.
1.
Disconnect power source before installing or
servicing fan. Failure to disconnect power
source can result
in property damage, serious
injury, or death.
2. When connected to an automatic controller,
FAN MAY START AT ANY TIME.
3.
When this fan is used in a life support ventilation
system where failure could result in loss or
injury, the user should provide adequate b
ackup
ventilation, or accept the risk of such loss or
injury.
4848
Fan HousingFan Housing
1.
Inspect fan for damage in transit. Check for
loose, missing, or damaged parts.
2. Do not ope
rate fan until you are completely
familiar with its operation.
INSTRUCTIONS PRIOR TO INSTALLATION.
BEFORE INSTALLING FANBEFORE INSTALLING FAN
1. Read WARNING statements before proceeding.
2.
Blades, motor, and wire guards should be
cleaned periodically to decrease vibration and
ensure maximum fan life. Remove dirt with a
dry brush or compressed air.
DoNotSprayMotorWithWaterOrCleaningFluids.
3.
Fan performance may be greatly reduced by
damaged or dirty fan guard. Clean and inspect
fan guard periodically to ensure maximum fan
performance.
REPLACEMENT PARTSREPLACEMENT PARTS
Description Part No.
Prop 6403-5012
Motor 3017-5000
Fan Guard 6403-0134
Hanging Kit 6450-7006
WARNING!WARNING!
