Hisense RS-19DL4SQ User manual

Built in Larder Service Manual
Factory MODEL : RS-19DL4SQ
DSG Model: CIL55W10
SKU : 084846

2 -
Content
1.Safety precautions ………………….…………………………………….3~4
2.Building in…………...…………………………………………………...5~6
3. Specification…………...………………………………..…………..…...7~7
4. Parts identification…………...………………………………..…….….8~8
5.Cooling system diagram………….………………………….………….9~9
6.Circuit diagram………………………………………………..………..10~10
7.Maintenance service and Troubleshooting …………..………………..11~12
8.Quality information report……………………………….…………….13~13
10.Exploded view and part list……………………………………………14~17

3 -
1. Safety precautions

4 -

5 -

6 -
2.Build in

7 -

8 -
3. Specification
models RS-19DL4SQ
net capacity (L) 140
color white
power supply(V/Hz) 220-240
rated input power (W) 90
net weight (kg) 33
gross weight(kg) 38
unit dimension (D*W*H)(mm) 545X540X872
packing dimension (D*W*H)(mm) 570X570X928
container quantity (PCS) 153
Noise 39

9 -
4.Parts identification

10 -
5.Cooling system diagram
when the refrigeration is just powered on. The refrigerant flows in the sequence:
Compressor Condenser Dry filter Capillary tube Evaporator .

11 -
6.Circuit diagram

12 -
7. Maintenance service and Troubleshooting
Cleaning and Care
For hygienic reasons the appliance interior, including interior accessories, should be cleaned
regularly.
Warning!
The appliance may not be connected to the mains during cleaning. Danger of electrical
shock! Before cleaning switch the appliance off and remove the plug from the mains, or
switch off or turn out the circuit breaker or fuse.
Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical
components, danger of electrical shock! Hot vapors can lead to the damage of plastic parts.
The appliance must be dry before it is placed back into service.
Important!
Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice or the juice from
orange peel, butyric acid, cleanser that contain acetic acid.
Do not allow such substances to come into contact with appliance parts.
Do not use any abrasive cleansers.
Remove the food from the refrigerator. Store it in a cool place, well covered.
Switch the appliance off and remove the plug from the mains, or switch off or turn out the
circuit breaker or fuse.
Clean the appliance and the interior accessories with a cloth and lukewarm water.
Commercially available dish washing detergents may also be used.
After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser increases energy consumption.
For this reason carefully clean the condenser at the back of the appliance once a year with a
soft brush or a vacuum cleaner.
Check the water drain hole on the rear wall of the fridge.
Clear a blocked drain hole with the aid of the green peg in the pack of accessories included
with the appliance.
After everything is dry place appliance back into service.
Trouble shooting
Correcting Malfunctions
Spare parts:
The following spare parts can be ordered from your local AEG Service Force Center. You can
fit these yourself without any special skill or training, e.g.:
butter/cheese compartment,
egg holders,
door racks,
fruit and vegetable drawers,

13 -
storage racks.
A malfunction may be caused by only a minor fault that you can rectify yourself using the
following instructions. Do not perform any other work on the appliance if the following
information does not provide assistance in your specific case.
Important!
Repairs to refrigerators/freezers may only be performed by competent service engineers.
Improper repairs can give rise to significant hazards for the user. If your appliance needs
repairing, please contact your specialist dealer or your local Service Force Center.
Symptom Possible Cause Remedy
Appliance is not switched on. Switch on the appliance.
Mains plug is not plugged in or is
loose. Insert mains plug.
Fuse has blown or is defective. Check fuse, replace if
necessary.
Appliance does not work.
Socket is defective. Mains malfunctions are to be
corrected by an electrician.
Appliance cools too much. Temperature is set too cold. Turn the temperature
regulator to a warmer setting
temporarily.
Temperature is not properly
adjusted. Please look in the “initial Start Up” section.
Door was open for an extended
period. Open the door only as long as necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature
regulation to a colder setting
temporarily.
The food is too warm.
The appliance is near a heat
source. Please look in the “installation location” section.
Interior lighting does not
work. Light bulb is defective. Please look in the “changing the Light Bulb “section.
Heavy build-up of frost,
possibly also on the door
seal.
Door seal is not air-tight(possibly
after reversing the door). Carefully warm the leaking sections of the door seal with
a hair dryer(on a cool setting).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
Appliance is not level. Readjust the feet.
The appliance is touching the wall
or other objects. Move the appliance slightly.
Unusual noises.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
If necessary, carefully bend
the component out of the way.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred. The compressor starts after a period of time.
Water on the floor or
storage shelves. Water drain hole is blocked. See the “cleaning and care” section.

14 -
7. Quality information report Quality information
Thank you very much for purchasing ourproducts. In order to provide you with more satisfied products,
please kindly fill in the questionnaire as the items indicated below. We shall strive for best to optimize our
products based on your suggestion。
Client name
Sale area
Date
No.
Product
model
Quality problem
describe
Service
result
Quantity
/rate
Factory serial No.
1
2
3
4
5
6．Quality problem of whole sale product: detail descriptions
client suggest：
Factory activity：

17 -
10 120369 Block 0.10 1 TB04-08(F) 卡环
11 141073 Knob 0.20 1 TB04-04(J) 调温旋钮
12 9140700122 Thermostat 4.50 1WDF30K-921-028 温控器
13 1701143 Screw ST4x12 0.10 1 GB845-76 自攻螺钉 ST4x12
0Cr18Ni9
14 9210200694 Lower hinge cover 0.30 1 BCD275/HC(E).00-11 下门铰盖
15 9110200565 Lower hinge pad 0.60 1 BCD275/HC(E).00.05-02 下门铰座
16 9110200666 Left support 2.00 1BC215/HC(E).00-05 左支承
17 1701183 Flange screw M5x16 0.05 10 BDG36-20 法兰面螺钉 M5x16
18 9110200665 Right support 0.60 1 BC215/HC(E).00.03-01 右支承
19 9120400558 Lower hinge parts 1.40 1 BCD275/HC(E).00.05-00 下门铰部件
20 9141000200 Door switch 0.90 1 BDG16-37 门开关
21 9210100212 Crisper drawer 6.00 2 BC215/HC(E).00-01 果菜箱
22 9210200693 Crisper box cover parts 2.50 1 BCD275/HC(E).00.03-00 果菜箱盖部件
23 9210501518 Shelves parts 4.50 2 BCD275/HC(E).00.02-00 层架部件
24 9120400550 Hinge core connecting
block 0.10 1 BCD275/HC(E).00.01-02 铰芯连接块
25 9120400551 Upper hinge core 0.20 1 BCD275/HC(E).00.01-03 上门铰芯
26-27 21049 eggs tray 0.50 2 BCD193.06-15 蛋格
28 9210500455 Upper shelf 2.90 1BC118/HC(E).03-06 中搁架
29 9210500456 Lower shelf 3.00 1BC118/HC(E).03-07 下搁架
30 9160100487 Door gasket 2.50 1BC145Q/HC(E).03.01-00 门封
31 9100502496 Door 16.00 1BC145Q/HC(E).03-00 门
32 13061 Drier filter 1.50 1 BDG27-05 干燥过滤器
33 55145 Compressor 45.00 1压缩机
34 915010026 Compressor connecting
wire 0.50 1 BDG35-00 压缩机连接线
35 6170300013 Screw nut M5 0.10 2 GB/T 6170-85 螺母 M5 H62
36 915010025 Compressor ground
wire 0.05 1 BDG34-00 压缩机接地线
37 170110 Screw nail M5 x12 0.05 2 GB818-85 螺钉 M5 x12 H62
38 170462 Round-pad 5 0.06 2 GB862.1-87 外齿锁紧垫圈 5 65Mn
39 9170400106 Round-pad5(H62) 0.06 2 GB95-85 垫圈 5 H62
40 170414 Round-pad5(65Mn) 0.06 2 GB93-87 垫圈 5 65Mn
41 9110800276 Compressor base parts 3.90 1 BCD275/HC(E).00.08-00 压缩机托板部件
42 170261 Screw assembly M6 x16 0.05 4 BDG36-03 组合螺栓 M6 x16
43 1701180 Screw nail M5 x12 0.05 2 GB818-85 螺钉 M5 x12 镀锌钝
化
44 17034 Screw nut M5 0.05 2 GB6170-86 螺母 M5 镀锌钝化
45 9101300702 Ground wire cover 0.10 1 T00-79 接地线盖
46 170113 Screw ST4.2x9.5 0.05 1 GB845-85 自攻螺钉 ST4.2x9.5 镀
锌钝化
47 1501280 Power supply cord with
plug 4.00 1 TB00.02A-00(C) 双圆插电源线

18 -
48 9110400131 Front leg 0.50 2 TB00.01C-00 前脚
49 17023 Screw bolt M6x30 0.05 4 GB5783-86 螺栓 M6x30 镀锌钝
化
50 17044 Round-pad 6 0.05 4 GB96-85 垫圈 6镀锌钝化
51 17042 Round-pad 6 0.05 4 GB93-87 垫圈 6 65Mn
52 170355 Screw nut M6 0.05 4 GB6175-86 螺母 M6 镀锌钝化
53 17013 Screw ST4.2x13 0.05 8 GB845-85 自攻螺钉 ST4.2x13 镀
锌钝化
54 9110600185 Drip tray 1.50 1 BCD325WY/HC(E).00-09 接水盘
55 1701131 Screw nail 0.05 1 T00-22 自攻螺钉
56 9210200665 Junction box parts 0.05 1 TB00.29-00 接线盒部件
57 13031 Process tube 1.00 1 T00-07 封尾管
58 1302332 Backside condensator 5.50 1BC118/HC(E).00.04-00 后背式冷凝器
59 DSGCSS145 Instruction Manual 0.40
60 IG5510 .Installation Guide 0.10