
Cleaning and Care
For ygienic reasons t e appliance
(including exterior and interior accessories)
s ould be cleaned at least every two
mont s.
Warning!
To avoid electrical s ock, t e appliance
must not be connected to t e main power
supply during cleaning. Before cleaning,
switc t e appliance off and remove t e
plug from t e main socket.
Exterior cleaning
To maintain good appearance of your
appliance, you s ould clean it regularly.
●
Spray water onto a cleaning clot instead
of spraying directly on t e surface of t e
appliance. T is elps ensure an even
distribution of moisture to t e surface.
Clean t e doors, andles and cabinet
surfaces wit a mild detergent and t en
wipe dry wit a soft clot .
Caution!
Don’t use s arp objects to clean wit , as
t ey are likely to scratc t e surface.
Don’t use T inner, Car detergent, bleac ,
et ereal oil, abrasive cleansers or organic
solvent suc as Benzene for cleaning.
T ey may damage t e surface of t e
appliance and may cause fire.
Interior cleaning
You s ould clean t e appliance interior
regularly. It will be easier to clean w en
food stocks are low. Wipe t e inside of t e
fridge freezer wit a weak solution of
backing soda and water, and t en rinse
wit warm water using a wrung-out
sponge or clot . Wipe completely dry
before replacing t e s elves and baskets.
T oroug ly dry all surfaces and removable
parts before putting t em back into place.
Alt oug t is appliance automatically
defrosts, a layer of frost may occur on t e
fridge compartment’s interior walls if t e
fridge door is opened frequently or kept
open too long. If t e frost is too t ick,
c oose a time w en t e fridge is nearly
empty and proceed as follows:
1. Remove existing food and accessories
baskets, unplug t e appliance from t e
main power and leave t e doors open.
Ventilate t e room t oroug ly to
accelerate t e process.
2. W en defrosting is completed, clean
your fridge as described above.
Warning!
Do not use s arp objects to remove frost
from t e freezer compartment. Only after
t e interior is completely dry s ould t e
appliance be switc ed back on and
plugged back into t e main socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick to
t e cabinet and tear w en you open t e
door. Was seal wit a mild detergent and
warm water. Rinse and dry it t oroug ly
after cleaning.
Caution! Only after t e door seals are
completely dry s ould t e appliance be
powered on.
Replacing the LED light
Warning: T e LED lig t must be replaced
by a competent person. If t e LED lig t is
damaged, follow t e steps below:
1. Unplug your appliance.
2. Remove lig t cover by rising up and
pulling out t e LED lig t.
3. Hold t e LED lig t wit one and and
pull it wit t e ot er and w ile pressing
t e connector latc .
4. Replace LED lig t and snap it correctly
in place and recover t e lig t cover.
11