
12
3
English CORDLESS LANTERN UB18DSL INSTRUCTION MANUAL
Lamp cap
323-519
Fluorescent lamp
323-339
Lamp cover
323-340
LED
Knob
Handle
Latch
Battery
Latch
Battery
Lamp cover
1
2
3
Reflector
326-194
4
UB 18DSL
Please read the following instructions throughly before using this lantern and use it correctly.
CAUTION:
●Do not touch the fluorescent tube while lit or right after
using. Touching it might cause burns.
●When hung from a high position always secure it
with string or similar item so it won’t fall. If it falls,
injuries might result.
●Always turn the switch off(OFF) when not using or when
replacing the fluorescent lamp.
●Do not use in the rain.
●Do not disassemble, strike or otherwise apply impacts to
the lantern body.
●Do not let gasoline or thinner get on the lantern body.
●Do not leave the lantern in places that reach high
temperatures (60°C or higher) such as in vehicles under a
blazing hot sun.
Doing so might cause the lantern to break down.
●Do not use any other than the specified storage batteries.
NOTE: Do not leave the switch in the ON position while not in use. This will shorten the life (charge/discharge times) of the battery.
SPECIFICATIONS
Battery BSL1430 (sold separately)
Fluorescent lamp Compact FL9W (Code No.323339 for replacement fluorescent lamps.)
Operating time Fluorescent light: Approx. 3.5 hours LED: Approx. 150 hours (Using full charged 3.0Ah Battery)
Dimensions height 305mm × width 95mm × depth 96mm (without battery)
Weight 0.5kg (without battery)
HOW TO USE
1. Inserting or removing the battery (See Fig. 2)
To install, make it face the same as battery and insert
inwards in the direction in the figure.
To remove, extract it towards the direction while holding
down the latch of battery.
2. Replacing the fluorescent lamp (See Fig. 3)
Turn the lamp cover in the direction and remove
it. Remove the reflector and lamp cap and replace
the fluorescent lamp.
After replacing with the new lamp, install the reflector and
lamp cap and reinstall the lamp cover in the direction .
AUTOMATIC SWITCHING FUNCTION
The lamp automatically switches to the LED to prevent total loss
of light when the battery wears down.
* When the BSL1430 battery is used, LED may not be turned
on due to the battery’s over discharge protection.
NOTE: Only parts 1,2,3 and 4will need replacement.
Important notice on the batteries for the Hitachi cordless
power tools
Please always use one of our designated genuine batteries. We
cannot guarantee the safety and performance of our cordless
power tool when used with batteries other than these designated
by us, or when the battery is disassembled and modified (such
as disassembly and replacement of cells or other internal parts).
UB18DSLEng.Kor.indd1UB18DSLEng.Kor.indd1 2011/07/3010:04:492011/07/3010:04:49