BATTERY CHECKER LAYOUT
Buttions
l.Battery Type: NiCd/NiMH,Li-Po,LiFe,Li-lon
2.Cell Number: NiCd/N iM H(4-7 Cells), Lithium type(2-7 Cells)
3.Display Mode:Battery cell voltages,total voltages,Lowest cell voltage, Highest cell voltage, Voltage gap between highest
cellvoltage and lowest cellvoltage, Remaining battery capacity(%)
+ NiCd/NiMH Type Battery lnput
- Lithium Battery lnput
\ (Using balancing connector)
NiCd/NiMH TYPE BATTERY
. Battey total voltage . Set cell numbers.
r*m-#Sft
.-9r9rgfi;
Total voltages,and remaining capacity(%)
n.b. The capacity shown for Nixx type cells is not accurate and should not be relied upon
NiCd and NiMH batteries for the TX and RX (4-7 cells) can be connected to this capacity checker
(
LITHIUM TYPE BATTERIES rdEE&
/v\,^/\xn
1S2$3S4S 55 65 75
:_B__B-gg ;.' j# i,:ii"'":rr'
. Highest/lowest call voltage d splay showing
h qhest cell number/lowest cell n!mber and
the voltage gap
Total voltaqe(%)
. Highest cell voltage
Showing the highest cell number,voltage
and remaining capacity
. Lowest cell voltage
Showing the iowest cell number,voltage
and remaining capaciiy-___
. JST EH and JSTXH type plugs on lithium battery packs can be directly connected to this battery checker
WhenusingwithThunderPower/FlightPower and Polyquesttypebatteries, it is necessaryto use an adaptor
board with balance adaptor board lead.
FS -BLEAD
FS.BAPQ
FS -BATP
Balance Adaptor Board Lead
Balance Adaptor Board Folyquest
Balance Adaptor Board Flight Power/Thunder Power
-0Fo
t[F6
LGlo[
['Jdu]H
0ttiad
C€