Hoco Technology Development (Shenzhen) Co., Ltd.
Product Features
Dial switch
Built-in 12 fixed dials, dial push and custom dial: a dial will
be added for replacement (this function needs to be set in
the dial settings after the watch is connected to the APP),
watch dial switching: Method 1: long press the screen on
the dial interface.Method 2: switch manually.
Heart rate monitoring
24h continuous heart rate monitoring throughout the day,
the APP side enables timing detection, this interface displays
the heart rate data of the day.
Sleep
This interface displays the sleep monitoring status of the
day, the data is updated every day, and the connected
APP can upload and save the data synchronously.
Weather
After the watch is connected to the APP and the location
permission is enabled, the weather interface will display the
real-time weather temperature and weather type.
Control panel
Do not disturb mode (after turning on this mode, the
watch will not receive information push and call reminders,
also brightness adjustment, settings, find the phone,
audio call mode turned off).
Message
Turn on the push of relevant information on the APP
side, the watch side can receive the corresponding
message push, up to 15 messages can be saved, if the
upper limit is exceeded, it will be automatically overwritten.
Music
After the watch is connected with the APP, you can
turn on and control the phone music playback.
Workout: 20 sport modes
Conditions to be met for data storage at the same time:
Pedometer: 2 minutes & 200 steps. Ball: 2 minutes & 1kcal. Skipping rope: 2
minutes & 20 times.
Notice:1. The watch needs to be worn on the hand to monitor the heart rate
before starting to calculate the data. 2. After the data is saved, record it in the
APP sports interface - click the center of the interface to view the sports details.
Pedometer status
This interface displays the number of steps, distance and calories
respectively. The target value of the number of steps can be set
on the APP: My target number of steps. The principle of step
counting: through arm swing and gravity induction. Step counting
method: the step counting interface will update every 10 steps.
Dialpad
You need to connect to Bluetooth 3.0+5.0 and enter the
number on the dial to realize Bluetooth calls.
Bluetooth calling
In the control panel, click the call icon in the lower right corner
to enter the call Bluetooth settings. After it is turned on, it can
be searched to use the mobile phone to connect to the Bluetooth
below, and then the call function can be used.
Call records
After connecting Bluetooth 3.0+5.0, you can view it on
the watch side (you need to pay attention to all the
permissions prompted when connecting and click Allow).
