
Holden Commodore Owner Manual (Holden-Localizing-Australia/New Zeal-
and-13711077) - 2020 - CRC - 8/22/19
12 Keys, Doors, and Windows
.The battery voltage is too low.
.Overload of the central locking
system by operating at frequent
intervals. The power supply is
interrupted for a short time.
.Interference from higher-power
radio waves from other sources.
To rectify the cause of the fault,
change the position of the RKE
transmitter or use the mechanical
key to unlock the doors, see Door
Locks 013.
Memorised Settings
Whenever the ignition is switched
off, the following settings are
automatically memorised by the
RKE transmitter:
.Automatic climate control.
.Lighting.
.Infotainment system.
.Door locking system.
.Sport mode settings.
.Comfort settings.
This is set for each RKE transmitter.
The saved settings are
automatically used the next time the
ignition is turned on with the
applicable memorised transmitter.
A precondition is that
Personalisation by Driver is
activated in the Settings menu in the
infotainment system.
The status change is available only
after locking and unlocking the
vehicle.
For vehicles with memory power
seats, the assigned memory
position of the power seat is
automatically recalled when
switching the ignition on and Auto
Memory Recall is activated in the
infotainment system for the
memorised RKE transmitter. See
Memory Seats 043 or
Vehicle Personalisation 0114.
Remote Vehicle Start
Remote vehicle start allows the
engine to be started from outside
the vehicle.
The remote vehicle start button /is
on the Remote Keyless Entry (RKE)
transmitter.
The climate control system will use
the previous settings during a
remote start and if the vehicle has
heated seats, they may come on
during a remote start. See Heated
Front Seats 045 and
Heated Rear Seats 050.
Starting the Vehicle
To start the engine using the remote
vehicle start feature:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release Q.
3. Immediately after completing
step 2, press and hold /for at
least four seconds or until the
hazard warning lights flash.
The hazard warning lights
flashing confirms the request to
start the vehicle remotely has
been received.