Holley B&M 81161 User manual

Rev 06/06/19 Page 1 of 4
www.bmracing.com
Technical Support [phone]
1
2
3
InstallaƟon InstrucƟons
81161
2015ͳ19 FORD Fͳ150
2.7L, 3.0L, 3.3L, 3.5L, 5.0L ENGINE
AutomaƟc Transmission
ITEM # PART # DESCRIPTION QTY.
1 4001777-88 ShiHandle Body 1
2 2480446-88 Push Buon Switch 12MM 1
3 3401652 8.5" Black Nylon Cable Tie 1

81161
Rev 06/06/19 Page 2 of 4
www.bmracing.com
Technical Support [phone]
3. Turn key to “Accessories” then shiinto “D” (Drive)
so you can remove console frame. Then pull frame
backwards and up to remove it completely.
4. Loosen and retain screws (x2) securing cupholder,
then liand release but do not completely remove
it from console.
5. Unplug wiring from base of shier and remove
screws (x2) from front of shier. Retain screws for
later use.
2. Open center console lid then liand release
console frame around shier.
REMOVE STOCK COMPONENTS:
OVERVIEW:
1. Take a moment to read and understand these
instrucons before installing your B&M Magnum
Grip Handle.
NOTE: Please inventory all parts now before connuing
and if necessary, report any missing items to our tech
line. This will avoid potenally stranding your vehicle
unl any missing replacement parts arrive.
WARNING:
For maximum safety, perform this installaon on a
clean, level surface with engine turned off.
CAUTION:
Chock wheels and apply parking brake; do not proceed
unl you are confident your vehicle will not move.

81161
Rev 06/06/19 Page 3 of 4
www.bmracing.com
Technical Support [phone]
9. Your push buƩon switch (2) may be installed
anywhere on shier plate or within cab given that
its wire can reach shier base. Choose where you
would like it to go and drill a ⁄" hole. Install push
buon and route wire to shier base.
10. Insert push buon wiring into shihandle
connector, then plug connector into shier base
socket. Secure wiring using clips in boom of
shier base compartment.
6. Press tabs on shier base to remove it from boot.
7. Remove shier collar from boot being careful not
to tear cloth material.
8. Set shiŌhandle body (1) down onto factory shier
stem then install screws (removed step 5) into it.
Install Magnum Grip ShiŌHandle kit:
1
2
NOTE: In this example, we installed new replacement
“TOW/HAUL” buon into front poron of center
console, accessible but out of sight.
NOTE: Pin posion isn’t crical while wiring connector.

81161
Rev 06/06/19 Page 4 of 4
www.bmracing.com
Technical Support [phone]
13. Place console frame back into place and snap it
down into posion. Set shier back into “P” (Park).
11. Set cupholder frame over shihandle; then use
zip Ɵe (3) to secure boot to shihandle. Finally,
clip offzip e tail.
12. Press cupholder frame down then fasten it using
screws (x2) (removed step 4).
Congratulaons, the installaon of your B&M Magnum
Grip Handle is now complete!
NOTE: Noce this sck handle is designed with a notch
in its indent corner. To fasten boot, pull fabric over
indent and secure it with zip e. The zip e lock should
rest in shier notch as shown. In this way, you will
avoid creang a lump in boot cloth.
3