H
J
YOUR BEACH SANTA IS
NOW FULLY ASSEMBLED.
PLUG IN AND TURN ON TO
LET THE FUN BEGIN!
P
NOTE: Pull the IR Sensor through
the front of the (H) Body, through
the hole available in the (P) Under-
shirt, and then secure the IR
Sensor to the (J) Shirt using the
available hook and loop closures.
WARNING
This item is not a toy and should be used for decoration only. This item contains
small parts that can be a choking hazard. Keep all plastic and wire parts away from
children.
1. Please use the adapter supplied by manufacturer.
2. Please assemble item according to instructions. Connect all wires according to
matching color.
3. Children should be supervised by adults. Item should not be grabbed, as it
becomes a tipping
hazard. Keep flammables away from the adapter, as it heats up during operation.
Please view all instructions carefully before assembling. Save this instruction sheet
for future reference.
CARE AND STORAGE INSTRUCTIONS
For best performance operate your item indoors. When not in use, store this product
in its original packing. Keep away from heat and moisture.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: Reorient or
relocate the receiving antenna, Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. Consult the dealer or experienced radio/TV
technician for help.
CAN ICES-003(B)/NMB-003(B)
Sensor / Détecteur
5.9 V
Try Me / Essaie-moi / Pruébame
Sensor / Détecteur
© Seasonal Visions International
Berkeley, CA 94710
Tel: 1-855-428-3921
All Rights Reserved
MADE IN CHINA
3/3
7.27.1
IR SENSOR
Be sure nothing is
blocking the
sensor.
IR SENSOR
J
OPERATION INSTRUCTIONS:
1. Plug the power adapter into a standard power outlet and adjust the settings on the Function Control
Box, located in the (G) Body, as desired.
2. Settings:
Sensor /Détecteur
This switch mode will activate sound and animation when the Infra-red (IR)
sensor is activated and will operate for 1 audio-cycle with each activation. The
Infra-red (IR) sensor has a range of up to 2 m/6.5 ft. and will activate when
someone comes within an 80-degree angle from left-to-right, as well as from
above and below.
This switch mode allows the item to be activated only if triggered by using a Step
Here Try Me Activation Pad (Not Included). The item will operate for one audio
cycle with each Try Me activation. Otherwise, the item will stay off.
This switch mode will continuously operate sound and animation of the item.
Raise or lower the volume using the volume control turn dial, turn all the way
down to turn the volume off .
