Home Decorators Collection MARTHA STEWART WSMSL-28PB User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Whalen Storage Factory No.: 15548 Page #1 of 4
MARTHA STEWART LIVING CLOSET POLE STANDARD
BRUSHED NICKEL
Assembly Instructions
HDC #:2954705270 MFG #: WSMSL-28PB
Please read over the instructions; it will be a
time-saver in the long run.
Note: Before Assembly, please be sure to work on a soft flat
surface to avoid any damage to the finish.

Please call for replacement parts or assistance:1-866-942-5362
Whalen Storage Factory No.: 15548 Page #2 of 4
ASSEMBLY TIPS
Read all instructions BEFORE assembly.
Remove all hardware from box and sort by size.
Check to see that all hardware and parts are present BEFORE assembling.
Ask a friend to assist you with the assembly of this furniture.
To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
Please wait until all steps are completed before tightening bolts.
Make sure all bolts are tightly fastened before the unit is used.
THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM
WEIGHTS INDICATED. USE WITH PRODUCTS HEAVIER THAN THE MAXIMUM
WEIGHTS INDICATED MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY.
DISTRIBUTE WEIGHT EVENLY.
MAXIMUM RECOMMENDED WEIGHT LOADS
WARNING
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
1. Do not allow children to climb or play on or around this product.
2. Use this unit for its intended purpose only.
3. Make sure all bolts/screws are tightly fastened before the unit is used.
4. Check bolts/screws periodically and tighten them if necessary.
SHELF MAXIMUM LOAD: 40 LBS. (18.2KG)

Please call for replacement parts or assistance:1-866-942-5362
Whalen Storage Factory No.: 15548 Page #3 of 4
Parts List
Please read completely through the instructions and verify that all parts listed are present before
beginning assembly.
A-25 mm Metal Pole (x 1)
Hardware List
Please read completely through the instructions and verify that all hardware listed are present
before beginning assembly.
1- Open Pole Holder 2- Closed Pole Holder 3- M4 x 15 mm Self-tapping Screw 4- M4 x 16 mm Short Screw
(x 1) (x 1) (x 2) (x 6+1 extra)
Tools required (not provided): Rubber mallet, Phillips screwdriver,

Please call for replacement parts or assistance:1-866-942-5362
Whalen Storage Factory No.: 15548 Page #4 of 4
Assembly Instructions
1. Align and attach Closed Pole Holder (2) to side panels of cabinet (Sold Separately) using
three M4 x 16 mm Short Screws (4) through holes on holder into the pilot holes, as shown in
figure below. Repeat for Open Pole Holder (1).
Note: Ensure the flat edge of the Closed Pole Holder (2) is level before tightening the
screws completely.
2. Insert one end of the 25 mm Metal Pole (A) assembly into the Closed Pole Holder (2),
securing with M4 x 15 mm Self-tapping Screw (3). Repeat for the opposite end.
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Never use water to clean your furniture as it may cause damage to the finish.
Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
Keep product away from direct sunlight as it may damage the finish.
Check bolts/screws periodically and tighten them if necessary.
We hope you enjoy your purchase for many years.
Thank you for your purchase.
WSMSL-SKW
WSMSL-SKN
(Sold Separately)
WSMSL-HSCW
WSMSL-HSCN
(Sold Separately)
2
4
3
2
A