Home Decorators Collection SK17012 User manual

Thank you for purchasing this quality product. Be sure to check all
packing material carefully for small parts, which may have came
loose inside the carton during shipment. Count all parts and material
hardware, then compare with parts list to be sure all parts are
present. If any parts are missing or damaged, phone, fax, or mail to
our Customer Service Department for efficient and speedy service.
Please indicate the model number and code letter of part(s) needed.
IMPORTANT NOTE: Follow instructions listed below in proper
sequence as numbered to assure fast,easy and correct assembly.
2/15
LEFT DOOR-1PC
LOWER SIDE PANEL-2PCS
UPPER BACK PANEL-2PCS

cb
SHOULDER
NOTE: UPON OPENING, THOROUGHLY CLEAN ALL WOOD SURFACES TO REMOVE DUST
AND DIRT THAT MAY HAVE SETTLED ONTO THE FINISH DURING SHIPMENT. IN
ORDER TO PREVENT DAMAGE DURING ASSEMBLY. PLEASE ASSEMBLE THIS ITEM
WITH AT LEAST TWO PEOPLE.
HOW TO USE THE CAM-TOOL
NOTE: THE ARROWS ON THE HIDDEN CAM-LOCKS SHOULD POINT TO THE CAM-BOLTS.
ARROW
NOTE: TURN THE CAM-BOLT SCREWS UNTIL THEY
ARE TIGHT, THE SHOULDER SHOULD BE
AGAINST THE SURFACE OF THE PART.
ARROW
4/15

● ATTACH THE DOUBLE HOOK (l) TO THE TOP MIRROR FRAME (C) BY USING THE 1/2” L
FLAT HEAD SCREW (j).
FIG 1
5/15

● INSTALL THE WOOD DOWEL (a) AND THE CAM LOCK BOLT (b) INTO THE TOP PANEL (E).
● JOIN THE TOP PANEL (E) TO THE ASSEMBLED PART BY USING THE WOOD DOWEL (a) FIRST.
● ONCE JOINED, TIGHTEN CAM LOCK (c) ONTO BOLT (b) USING PRE-DRILLED HOLES.
● COVER CAM HOLES WITH THE LONG PLASTIC COVER (k).
● TIGHTEN THE TOP PANEL (E) AND THE TOP MIRROR FRAME (C) BY USING THE 1-1/2”L
FLAT HEAD SCREWS (h).
FIG 3
7/15

FIG 5
9/15
● ATTACH THE MAGNET (i) INTO BOTTOM OF THE FIXED PANEL (F) BY USING THE 5/8” L
ROUND HEAD SCREW (d).

FIG 7
11/15
● INSTALL THE WOOD DOWEL (a) AND THE CAM LOCK BOLT (b) INTO THE BOTTOM PANEL (H).
● JOIN THE LOWER SIDE PANEL (G) TO THE BOTTOM PANEL (H) BY USING THE WOOD
DOWEL (a) FIRST.
● ONCE JOINED, TIGHTEN CAM LOCK (c) ONTO BOLT (b) USING PRE-DRILLED HOLES.
● COVER CAM HOLES WITH THE SHORT PLASTIC COVER (e).

FIG 8
12/15
● INSTALL THE WOOD DOWEL (a) AND THE CAM LOCK BOLT (b) INTO BOTTOM OF THE
FIXED PANEL (F).
● JOIN TWO ASSEMBLED PARTS BY USING THE WOOD DOWEL (a) FIRST.
● ONCE JOINED, TIGHTEN CAM LOCK (c) ONTO BOLT (b) USING PRE-DRILLED HOLES.
● COVER CAM HOLES WITH THE SHORT PLASTIC COVER (e).

FIG 11
15/15
● PLACE THE SHELF PIN (n) IN DESIRED POSITION AND PLACE THE ADJUSTABLE SHELF (K)
ABOVE THE SHELF PIN (n).