2. Turn off power at fuse or circuit breaker.
WARNING:
Risk of electrical shock. Disconnect power at the
fuse or circuit breaker before installing or servicing.
Service and maintenance of this fixture should be performed
by a qualified and licensed electrician.
• Verify that the supply voltage is correct. Connect fixture to a AC100V-240V, 50/60 Hz power source.
• This fixture is intended to be connected to a properly installed and grounded UL listed junction box.
• Light fixture must be powered directly off a circuit box.
Risk of Fire, do not mount the unit against flammable surfaces.
Motion Sensor will not work correctly if it is installed:
• Near the outlet of a central heating boiler
• Near an air conditioning unit
• Pointing directly at moving vehicles
• Within sight of reflection of moving water
• Where other lamps could shine on the detector
• Fixture can’t be used with a dimmer switch, motion occupancy sensor and other electronic switching
devices unless otherwise designated.
• All wiring connections should be capped with UL listed wire connectors.
CAUTION
NOTICE
