HOMEDEPOT S-2712 User manual

ITEM NO: S-2712
ISSUED JUL 08, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
_____________________________________________________________________
Description
Item No.
: 24 IN BEDFORD LADDERBACK RTA
: S-2712

ITEM NO: S-2712
ISSUED JUL 08, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws, bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Back
1
B
Seat Frame
1
C
Seat
1
D
Front Leg
(L-R)
2
E
Side
Stretcher
2
F
Front Stretcher
1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO: S-2712
ISSUED JUL 08, 2014
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Short bolt
( M6x40mm)
3
2
Medium bolt
(M6x60mm)
4
3
Long bolt
(M6 x 80mm)
4
4
Wood Screw
(M4 x 35mm)
10
5
Lock Washer
(6.5 x11mm)
11
6
Flat Washer
(6.5 x19mm)
11
7
Allen Key
(4 x 80mm)
1
STEP 1
Attach seat frame (B) to the back (A) with bolts (3) and (1), and washers (5) and (6) as shown below.
Tighten with Allen key (7).
Note: DO NOT fully tighten any of the bolts, until the stool is assembled, then put on a flat level
surface to make sure the stool is level and then tighten the bolts. .

ITEM NO: S-2712
ISSUED JUL 08, 2014
Printed in Vietnam
- 4 -
STEP 2
Attach front legs (D) to the seat frame (B) with bolts (2), and washers (5) and (6) as shown below.
Tighten with Allen key (7).
Place side stretchers (E) and front stretcher (F) between front and back legs, attach with screw (4) as
shown below. Tighten with a screwdriver.
STEP 3
Attach the seat (C) to top of the seat frame (B) with screws (4). Tighten with a screwdriver.