HoMedics DS-CHAIR User manual

Step 1. Set up the chair
1) Attach Support Bar (A) between Chair Arms (I)
with 2 Screws (D)
2) Attach Seat Cushion (B) to Chair Arms (I) with
4 Screws (D)
3) Attach Seat Back (C) to Chair Arms (I) with 2
Screws (D) as shown
4) Attach Seat Back (C) to Seat Cushion (B) with
2 Screws (E) as shown
5) Attach Outlet (G) by sliding metal plate down
over mounting screws in right chair leg and
fitting Nut (J) over the screw to secure
Step 2. Set up the bucket
• Attach Bucket (F) to either armrest of your
HoMedics display chair
Assembly Instructions for Display Chair
Model # DS-CHAIR
Be sure that all the screws are fully tightened
before using.
Note: Massage Cushion is not included. Follow your buyer’s direction in pulling a
unit from stock for display. Please see a list of corresponding massage cushions &
display headers on next page (see step 3 on page 2).
IB-DSCHAIR Display Chair Model # DS-CHAIR
A. Support Bar 1
B. Seat Cushion 1
C. Seat Back 1
D. Screw (Ф1/4”x 11/4”) 8
E. Screw (Ф1/4”x 1”) 2
Parts List
Page 1
F. Bucket 1
G. Outlet 1
H. Allen Wrench 1
I. Chair Arms 2 (L and R)
J. Nut 1
B
C
F
E
GJ
A
I
D

Display Chair Instructions
Step 3. Display the massage cushion on the chair
When the DISPLAY CHAIR is fully assembled, remove a cushion from its packaging for use
with the display chair.
Follow your buyer’s direction in pulling a unit from stock for display. HoMedics
massage cushions will match the new headers that have shipped with this item or
separately.
TO INSTALL CUSHION ON CHAIR:
1. Use the provided Allen wrench to remove the screw located at the bottom of the
back cushion. Properly dispose of the screw.
The Shiatsu/Quad-Roller Massaging Cushions will not function unless the
screw is removed.
2. Slip the straps located on back of massage cushion onto back chair cushion and
adjust fastening straps to secure. The massager should not be able to slip or slide
away.
3. Plug the power cord into the outlet (G) that comes with the display chair, and plug
the outlet into a 120 volt AC outlet. Be sure to turn on the power switch on the
outlet.
4. Open “Demo – Try Me” lid on control arm. Slide hand control into the handset
holder integrated into the right armrest of chair. Secure hand control cord by
closing the “Demo – Try Me” lid and snapping shut.
5. If you have not already done so, Insert square end of display header into pocket
located on the backside of the BACK CUSHION (C).
IB-DSCHAIR Display Chair Model # DS-CHAIR
Page 2
Header Model # Cushion Model #
HDC-SBM-200H SBM-200H
HDC-SBM-300H SBM-300H
HDC-SBM-305MH SBM-305MH
HDC-QRM-400H QRM-400H
HDC-SBM-500H SBM-500H
HDC-MCS-300H MCS-300H
HDC-MCS-400H MCS-400H
HDC-MCS-600H MCS-600H