hometreats KA917 User manual

hometreats
CANDY FLOSS MAKER
KA917
Body Bowl Black Connector Clip Clear Top Guard
Extractor Head
Parts List
Please review the user manual carefully before first use. Always
follow the safety precautions & cleaning instructions exactly.
Please retain these instructions for future reference
Candy Floss Straws x 10 Measuring Spoon

Initial Product Assembly
STEP 1: Unpack and
separate parts.
STEP 2 : Ensure the extractor head is on.
Align the extractor head onto the stem &
groove in the body
STEP 3 : Place the bowl onto the body. Push down and twist an-
ti-clockwise onto the metal grooves of the body to secure.
STEP 4: Place the black
connector clip over the
clear top guard.
STEP 5: Attach the top guard and
connector clip onto the bowl. Press down
firmly all sides of the connector. Ensure all
6 clips attach.
Product on arrival
Ready for storage
Assembly complete - reverse steps to pack away for small cupboard storage
Remove all product packaging & clean before first use. Cleaning instructions Pg 6

Assembly complete - reverse steps to pack away for small cupboard storage
Intended use
• The appliance is designed for domestic use only. Not for commercial use
• This appliance is intended for use by adults only
• Ensure children are always closely supervised with instruction on how to use the appliance in
a safe way & understand the hazards
• Appliances can be used by persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
• Cleaning, perpetration & maintenance should be performed by an adult who understands
the instructions.
• Keep the appliance and cord out of reach of children when not in use
• Do not use appliance for other than intended use.
• This appliance is intended for use with granulated sugar or candy floss sugar only.
• This appliance is only intended for us after initial set up guide has been followed
• This appliance should only be used when all packaging materials have been fully removed.
WARNING
Declaration of Conformity
This declaration is issued under the sole responsibility of the product manufacturer.
We Doodle Products Ltd hereby declare that the product described above, to which this
declaration of conformity refers to, is in conformity with the essential requirements of the
following standards:
Low Voltage Directive 2014/35/EU
EMC Directive 2014/30/EU
Materials & Articles in Contact with Food 1935/2004/EC
Restriction of Hazardous Substances Directive 2011/65/EU
Issued By: Doodle Products Ltd Quality Assurance Team
Unit M1, Heywood Distribution Park, Heywood, OL10 2TR

1. For indoor household use only.
2. Do not touch the hot surface while in use.
3. To protect from electrical shock do not immerse cord, plug or any part of the body in
water or any other liquids.
4. Close supervision is necessary when this appliance is used near children.
5. Unplug the appliance from outlet when not in use and before removing parts for
cleaning.
6. Do not operate any appliance with a damaged cord or plug or if the appliance has
been damaged in any way.
7. The appliance manufacturer does not recommend the use of any accessories or
attachments.
8. Do not leave the cord or unit on the edge of a table or counter.
9. Do not place on or near a hot gas stove, electric burner or near a heated oven.
10. Extreme caution must be employed when moving this appliance.
11. Do not use the appliance for usage that it is not intended for.
12. Do not leave the unit unattended while in use or when plugged in to an outlet.
13. Check inside the heating element compartment for foreign objects before switch-
ing to ON position.
14. The heating element & extractor head get hot. Avoid contact until cool.
15. The marked electrical rating of an extension cord should be at least as great as the
electrical rating of the appliance.
16. Keep hands away from the machine when it is in the ON position and is
spinning.
17. Always use the unit on clean flat surface using the suctions pads to secure
18. Always ensure all parts are fully dry after cleaning
19. Only add sugar when the unit is in and off position and has fully stopped
Safety Precautions
After use ensure unit is turned off, unplugged and has had adequate time to cool
before touching or moving.
Do not immerse in water. Do not use near water
Do not use an abrasive sponge, scouring pad or cloth.
Do not leave any unit unattended while in use.
Do not place anything other than the intended sugar in the extractor assembly head
Always unplug the unit from outlet when not in use and when cleaning
Do not operate this appliance with a damaged cord or plug or in the event that the
appliance ever malfunctions.
Do not put in dishwasher.
Keep out of reach of children, this is not a toy.
Clean before first use clean the extractor head, bowl, connector clip & top guard.
Only use 1 exactly 1 scoop of granulated sugar or candy floss sugar in the centre of
the extractor head. Getting sugar in other areas or using other ingredients could burn
the sugar
Safeguards

Using Your Candy Floss Maker
Set up the unit in accordance to the initial set up guide. If parts have been cleaned ensure
all parts are dry. Make sure the unit is secure on clean level surface away from water.
1. Plug in the unit at the OFF position
2. Turn the unit to ON position and allow it to
run for at least 5 minutes. This will allow it to
warm up. Then switch to OFF.
3. Measure a level tablespoon of sugar with the
measuring spoon supplied . Pour sugar into silver
centre of the extractor head when it is stationary.
Switch to ON position. The candy floss maker will
spin delicious cotton candy strands in circles
around the bowl
Pre-Heat The Unit
Pour The Sugar
1 Scoop of
sugar here
4. When you can see the cotton candy web in the bowl, collect the cotton candy on the
straw.
4a. Hold the straw vertically in the bowl, spin the straw with your fingers while you circle
the bowl this will gather first strands on the straw.
4b. Once some cotton candy has collected on the straw then hold the straw in a
horizontal position over the extractor head. Continue spinning the straw with your fingers
in the horizontal position and moving from side to side to gather the strands.
Collect The Candy Floss
4a. Vertical collection to get
the first strands
4b. Horizontal collection to
gather cotton candy

Thank you for your purchase, we hope you enjoy your product. If so please let
other buyers know what you think by leaving 5 star feedback.
In the unlikely event of a problem please contact our customer service from the
purchase website, we are on hand to help solve the issue in a ma�er of hours.
hometreatsuk.com
Email: [e-mail]
Phone: [phone]
5. Turn the unit OFF when all the sugar has been dispensed. Once the extractor head
has come to a complete stop, you can pour another measure of sugar in the extractor
head and begin again without pre-heating.
6. Enjoy tasty, fluffy cotton candy from your Cotton Candy Maker!
NOTES:
For optimum results be sure to turn unit ON and allow it to pre-heat before starting.
Only add sugar to the extractor head when it has come to complete stop. Never use
ingredients other than pure granulated sugar. This will cause clogging. DO NOT overfill
the sugar receptacle.
The Cotton Candy Maker breaks into base, bowl, extractor head, top guard and
connector clip assembly for easy cleaning
1. Make sure the unit is unplugged and has had time to cool down before cleaning.
2. After cooling, remove the extractor head assembly by pulling it straight up. Unlock
the bowl by turning clockwise and remove.
3. Wash the bowl, top guard, connector clip, extractor head in warm water & rinse. Air
dry or dry with a clean non abrasive towel.
4. Ensure all parts the absolutely dry before returning to base
NOTES:
It is very important that the unit be cleaned properly after every use.
The holes may get clogged and sugar will not be able to sift through the tiny holes
properly to create the candy floss.
Cotton candy is made by heated sugar. This turns sugar into a liquid form, then the
sugar liquid is forced out of tiny holes in the extractor head by centrifugal force as the
extractor head spins. As the liquid sugar hits the air, it returns into a solid fluffy mate-
rial that adheres to a paper cone.
Cleaning
hometreats
Supply Voltage : 220-240V~50/60Hz
Power: 500W
Model: KA917