honeybud Epic User manual

ANC BLUETOOTH HEADSET

For the Best Audio experience,it is recommended your right
size silicone earcaps and,please put your cellphones in the
same side of left earphone during outdoor.
Product details
Usage
L R
54 Touch Button
charging case digital
display
9
Type-C charging port
2
1Earphone digital display
Earphone charging port
7
8
Earphone indicator
6
3
Powering ON:
Method 1: Take out the earphones from the charging case, and
they will power on

Powering OFF
Method 2 When the earphones are OFF,Keep the touch button
of both earphones for 3-5 seconds.The Led light
flashes once and with a sound prompt:“power on”.
Method 1: The earphones will switch off when put into the
charger case.
Method 2: Keep the earphones touch button pressed for 3-5
seconds, until the Blue LED flashes with a sound
prompt: “power off”.
Note: If the earphones were disconnect with the device,
the earphones will be power off automatically after 5mins.
Keep the touch button
pressed for 3 seconds
R earphone blue
light flashes
L earphone blue
light flashes
1
Stereo Mode
Taking the earbuds out of the charging box, they will auto power on.
After a few seconds, the left and right earbuds will auto connect each
other.When the TWS earbuds are connected to each other, the LED
light will flash quickly. When TWS connected,the blue light flashes slowly.

Note: If the earphones connected the device once, and the bluetooth functions of device
was open, the earphones will be reconnected with last device automatically.
2
Open the bluetooth devices page inside settings.Search
for “Honeybud-B22” and select it to pair,the Earphone lights
be off after the earphones connected with device.
Setting
Bluetooth
Bluetooth
My device
Honeybud-B22
connected
My device
Honeybud-B22 connected
Blue light flashing
2Keep press the touch button for 1 seconds and release it
(“L”for previous song, “R”for next song)
1Touch the button once to Pause/Play.
Play Music:
Click L earbud three times to wake up Siri voice assistant.
Voice Assistant:
click R earbud three times to open ANC mode,then click three times to switch
to transparent mode，then click three times again to turn off the ANC mode.
ANC mode:

3Touch the button twice to adjust the volume(“L”for decreasing ,”R” for increasing)
3During a call, the volume can be controlled via the mobile phone.
4Stereo mode:both ears have voice.
1When a call comes in, short press one of the touch buttons in order to answer
the call or long press it to reject it.
2During a phone call, short press the earphone button to end the call and the
earphone will resume its previous working state.
Calling
Bluetooth version:V5.1
Maximum transmission range: 15M
Working temperature range: -10+50
RF Sensitivity: -92dBm
Operating frequency: 2.40 GHZ-2.48 GHZ
Bluetooth pro es supported: HFP/A2DP/AVRCP
Music playing time: About 5-7h*3Times
Earphone Charge time : Around 1.5hour
Battery capacity:
2*3.7V/50mAh
Voltage rating and energy capacity: 3.7V/400mAh
Packing list
Earphones *2
Charging case *1
Earcaps *4(L\ S)
User manual *1
Thankyou Card *1
Warranty Card *1
USB cable *1

Fault:
1
Host device is a connection between second device
and your mobile phone it is normal status under high
power condumption.
3
On iPhones the battery level of the earphones will be
displayed in real time.
4
When the earphones and the charger case are not used
for long periods of time, it is recommended to keep them in
a dry place and to recharge them at least every 2 months.
2
When not connected to any device, the earphones will
power off automatically after 5 minutes.
Important:
Can’t power on
No charging indication
Automatically shut down
The Earbuds have
an echo
Small sound
Signal intermittent
Earbuds have no sound
The Earbuds are noisy
Cause Solutions
Earbuds are low battery/
Crash
The Earbuds are not well put into
Earbuds are low battery
The volume is too high or
the environment is too noisy
wearing Earbuds incorrectly
or the volume is too low
Outside environment interference
or too far away from mobile phone
Pairing unsuccessful
between L and R Earbuds
Outside environment interference
or too far away from mobile phone
Adjust Earbuds position
charge the Earbuds
Adjust the volume or
change position
Adjust the Earbuds position
or the mobile phone volume
Change to better environment or
move closer to the mobile phone
Put the earphones into the
charger case
Change position,or move
closer to the mobile phone
Fault
Charge the Earbuds/Keep the
earphones touch button pressed
for 8 seconds