Honeywell ZSTAT Installation manual

- 1 -
Tech Support
Updated 6/7/11
Basic Programming for the Honeywell ZSTAT Thermostat and 5800ZBRIDGE
Notes before you begin:
•If you need help wiring your thermostat, please call 1-800-468-1502
oIf required please have a licensed professional install your product for you.
Programming the thermostat:
1. Press System:
2. Press the 3rd and 5th buttons simultaneously
3. Used the following buttons to program:
Use the Up and down
arrows to scroll through the
questions (fields).
Use the Up and
down arrows to
enter the desired
value.

- 2 -
Tech Support
Updated 6/7/11
The Follow locations are the bare minimum fields required for operation:
Enrolling the House ID in the Z-Bridge Module:
1. Make sure your House ID is set in the panel or local mode of the RF keypads.
a. The following devices are compatible
•6150rf
•6160rf
•5883H
•Lynx Control Panels
2. Press the SW5 Learn switch for 1 second then release.
a. LED will Flash Orange
3. Arm and disarm the control panel.
a. The LED will now show status of the panel.
Enrolling the Z-Bridge Module into the Honeywell Z-wave thermostat:
1. Navigate through the programming of the thermostat until you reach the following screen:
Setup
Functions (Fields)
Settings & Options (Factory default is in bold)
0120
Year (First 2 Digits)
20 (2000-2078)
0130
Year (Second 2 Digits)
11 (2011)
0140
Month
6(1-12)
0150
Date
15 (1-31)
0160
Schedule Format
0 (Non Programmable)
(Does not affect Z-Wave Operation)
4 (Programmable)
0615
Energy Saving Heat Setpoint
65°F (18.5°C)
40-90°F (4.5°C-32°C)
0616
Energy Saving Cool Setpoint
78°F (25.5°C)
50-99°F (10°C-37°C)

- 3 -
Tech Support
Updated 6/7/11
2. Next power up the Z-Bridge with the supplied 12v
power supply.
a. Upon power up the yellow LED will flash
3 times.
3. Press the corresponding switch (1-4) for 1 second
then release for any combination of four
Thermostats or Lights.
a. Switch 1 = Thermostat/Light 1
b. Switch 2 = Thermostat/Light 2
c. Switch 3 = Thermostat/Light 3
d. Switch 4 = Thermostat/Light 4
The LED on the Z-Bridge will begin flashing
green.
4. On the Thermostat, change the 0 to a 1 to learn the Z-Bridge.
Change this
value to a 1.
Once that is
done you will
see
Once learned in the LED will flash three times and return to the status of the control panel.
5. Press ‘Done’ to exit programming.
Notes:
1. To test the connectivity simply arm and disarm the panel and watch the LED on the Z-Bridge to
make sure it is illuminating properly (See Z-Bridge Installation Instructions).
2. To verify the Z-Bridge is communicating with the Thermostat look for the word ‘Saving’ which will
be present above the ‘Set To’ temperature. This represents the thermostat is in “Setback Mode’.
3. Locations 0615 (Heat Set Back) and 0616 (Cool Set Back) are End User Programmable. (See the
thermostat Owner’s Manual for more information)