Hooker Furniture 1618-75007-DKW User manual

ASSEMBLY INSTRUCTION
Item#: 1618-75007-DKW Trestle Dining Table Base
1618-75008-DKW Trestle Dining Table Top
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps：
1. Put table top (M) upside
down on a soft place to
prevent it from being
scratched.
2. Attach center leg (N) to table
top (M) as labeled by using
bolt (E), lock washer (C) and
flat washer (D). Tighten them
securely with allen wrench
(A). (See diagram 1)
3. Attach base leg (O) to table
top (M)by using bolt (B), lock
washer (C) and flat washer
(D). Tighten them securely
with allen wrench (A). (See
diagram 2)
Diagram1
Diagram2
M

4. Insert the stretcher
（
P
）
into
center hole of table base leg
(O) fix it by using bolt (B), lock
washer (C) and flat washer
(D). Tighten them securely
with allen wrench (A). (See
diagram 3)
5. Repeat step 4 to install
another side stretcher(p) into
table legs. Tighten them on
stretcher(P) left side securely
with threaded rod(F),lock
washer(K),flat washer(L) and
rubber gasket(J).Securely
them on the stretcher (P) right
side with leveler wrench (H),
nut (I), flat washer (L) and
rubber gasket (J). Securely
them on center leg with
leveler wrench (H),bolt
(G) ,lock washer(K),flat
washer(L) and rubber gasket
（J）. (See diagram 4)
6. Turn the table top upright. If
you want to place the leaf on
the table, please turn the
switch to “off” position
underneath top panel. Then
pull out two ends of top panel,
place it on top and push them
together, turn the switch to
“ON” position.
(See diagram 5&6).
7. When you adjust the table
top, please be sure to
unstrengthen bolt (G) on
center leg first.
Diagram3
Di
agram4
Diagram5&6
O

Instruction for table leaves:
1. There are latches at the bottom of table top, turn on the latch ,pull out table top as the arrow direction
shown in diagram 7.
2. Place table leaves (Q) between and push table tops together. Turn off latches. Put the server (R)on
table top(see diagram 8)
3. Take opposite actions to remove table leaves.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.
Diagram7
Diagram8
Q
R