Hooker Furniture 5048-85122 User manual

1/2
ASSEMBLY INSTRUCTION
Item#:5048-85122 THREE DRAWER THIN CONSOLE
** Please make sure you have all parts indicated below prior to assembly.
NO. HARDWARE LIST Q'TY
PLASTIC ANCHOR 2
2
HOOK
F
E
A
C
B
DD
C
CA
B
Diagram 1
Diagram 2
Assembly Steps:
1. Place console top (D) upside down on a soft surface to prevent from scratching top.
2. Attach posts (C) to top in a clockwise direction (See diagram 1).
3. Put bottom panel (B) on posts (C); insert bun feet (A)to posts through the bottom panel in a
clockwise direction (See diagram 2).
4. Turn the console upright.

2/2
ANTI-TIP RESTRAINTS：
E
Diagram 3
1. Place the console in a desired location. Mark wall with pencil.
2. Drill two holes into the wall using 1/4”drill bit and insert the plastic anchors (F).
3. Screw hook (E) into plastic anchor (F). Check and make sure the plastic anchor (F) is securely
held in the wall.
4. Set console in place and hang the metal rings attached at back of console onto the hook (E)
(See diagram 3).
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water
solution. Polish the finish with soft cloth and an industry recognized furniture polish.