DISCOVERY Suction Cleaners
Discovery Fitting Notes
Before carrying out any repairs on the appliance remove the following:
Dust Container
Press the dust container handle .
Rotate the handle clockwise and lift the dust container assembly out of the bag
housing.
Exhaust Filter
Lift up the rear vented cover and take out the exhaust filter assembly.
Top Cover/ Pedal /Lens Removal
Detach the dust container and exhaust filter as previously described.
The six screws securing the top cover,two at the rear and four at each corner of the
dust container compartment are now accessible.
Remove the six screws.
The top cover with the pedals and the bag full indicator lens can now be lifted away.
To change the pedals or bag full indicator lens, undo the two screws on the underside
of the top cover allowing the main control panel to be lifted off .
The pedals and lens can now be pushed out of the assembly as required.
Module
Remove the top cover.
The module is fixed to the motor housing by one screw situated 55mm from the rear of
the module.
Removing the screw allows the module to be lifted off.
When removing the module take care to note the position of the connector plugs and
amp tags fitted on it.
Re-fit in reverse order.
When replacing the module make sure that the plastic shoulder washer is fitted under
the head of the fitting screw.
CAUTION! If the two wire plug from the cord reel is inadvertently fitted in between the
two amp tags, the cleaner will run constantly when connected to the mains without the
need to actuate the on –off switch:-
DO NOT under any circumstances connect the lead in this position.
ON some models this position on the board may be used for the P T O Socket.
Motor and Cord Reel Removal
Remove the top cover.
Remove the four recessed screws around the dust container area.
Detach the cord reel two pin connector from the module.
The bag housing with the motor housing assembly and module attached to it can now
be taken out of the appliance.
The module can be serviced as before.
To Remove The Motor:-
Detach the remaining connectors from the module and separate the motor housing
from the bag housing.
