Hornby FOOTBRIDGE User manual

FOOTBRIDGE ASSEMBLY INSTRUCTIONS
The footbridge may be assembled in alternative ways as shown on the sides of the pack. To make a
more permanent structure polystyrene cement (not included) may be used to secure the side steps to
the overbridge base and for fastening the support posts and bases.
Fit sidewalls (1) to overbridge base (2).
Use the flexibility of the sidewalls to spring them
over the smoke deflector projections (3).
Clip on the four outriggers (4), engaging their tops as shown in inset (5).
Assemble side steps (6) to overbridge base noting how the small pegs fit.
Push the tops of the support posts (7) into the holes as shown in inset (8)
and add the support bases (9).
The side steps inner walls (10) may now be clipped into position.
Use their flexibility to engage their upper ends with the overbridge sidewalls.
1
2
31
2
1
5
4
8
7
96
10
9
10
6

Before clipping on the side steps outer walls (11), flex the upper
end ‘hinges’ between finger and thumb a few times to ensure the
hinges will bend to neat right angles when assembled (inset 12).
Again use their flexibility to engage them with the ends of the
overbridge sidewalls.
3
12
11
11
Printed in China
4/298C
Hornby Hobbies Limited, 3rd Floor, The Gateway, Discovery Park, Sandwich, CT13 9FF. UK.
Tel: [phone] www.hornby.com