Hosantech Bario User manual

Owner′′ s Manual

3 2
INTRODUCTION PACKAGE CONTENTS
Thank you for choosing this product.
Please read and observe all warnings and instructions in this owner‘s Manual before use
and retain this booklet for future reference.
1.Main Body
2.Protection Shield
3.Cover
4.Callus Debris Container
5.Abrasive Plate
6.Power Adaptor
7.Cleaning Brush
8.Owner’s Manual

5 4
IMPORTANT SAFETY INSTRUCTIONS
DANGER
CAUTION
SAVE THESE INSTRUCTIONS
WARNING
When using“BARIO”electric callus remover especially when children are present,
basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPARATUS.
Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
Do not use outdoors or operate where aerosol(spray) products are being used where
oxygen is being administrated.
Avoid to be used by, on, or near children.
Keep the cord and plug away from heated surfaces.
Be certain that plug is inserted firmly into this apparatus. To disconnect, turn this
appliance off then remove plug from outlet.
Never use while sleeping.
Do not use an extension cord with this appliance.
Before plugging in, read the information about dual voltage contained the instruction
section of the manual
Stop using this product immediately if you feel pain.
Do not touch shaft of the motor, abrasive duct, etc. while the main body is in operation.
Stop using this product immediately if you hear any unusual noise.
Stop using this product immediately if the main body is hot.
When operating the main body, keep it more than 50cm(20inch) away from face.
Do not allow the callus debris to get into the eyes, nose, mouth and ear.
Do not use this apparatus when you have a skin or nail disease.
For extremely thick callus, dermatitis, or blood circulation disorder, please consult with your
doctor before use.
Wipe this product with a dry cloth. Do not use chemical agents including benzene and
alcohol.
When using this apparatus, lay mats on the floor as callus debris may be scattered around.
Keep this product in a dry area with all parts completely dried.
Do not drop this apparatus, this may lead to damage, break up or malfunction.
When in use, do not let the abrasive plate be applied to anyone area of the foot, this may
generate frictional heat, causing pain and wounds.
Do not use this apparatus for more than 10 minutes a time, 30 minutes a day.
Before use, make sure that the abrasive plate is in normal condition. Any malformation,
distortion, damage may cause skin injury.
Do not push too forcefully to stop the abrasive plate. Stopping of the abrasive plate during
use may lead to overload, causing malfunction.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
5
6
7
8
9
10
11
12
TO REDUCE THE RISK OF ELECTROCUTION:
Always unplug this appliance immediately after using.
Do not use while bathing.
Do not place or store where appliance can fall or be pulled into tub, toilet, or sink.
Do not place in or drop into water or other liquid.
If appliance falls into water, unplug immediately. Do not reach into water.
1
2
3
4
5
1
2
3
4
TO REDUCE THE RISK OF BURNS, FIRE, ELECTROCUTION, OR INJURY TO PERSONS:
An appliance should never be left unattended when plugged in.
Close supervision is necessary when this appliance is used by, on, or near children or
individuals with certain disabilities.
Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by the manufacturer.
Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, or if it has been dropped, damaged, or dropped into water. Return the appliance
to a service center for examination and repair.

7 6
INSTRUCTIONS HOW TO ASSEMBLE / DISASSEMBLE
OPERATION INSTRUCTIONS
USER-MAINTENANCE INSTRUCTIONS
HOW TO DISASSEMBLE
HOW TO ASSEMBLE
Open the cover.
Plug the adapter into the wall outlet and connect opposite end to the port or the main body.
Set the operation level to level 1.
Grip the main body firmly and apply it to the callus for removing the dead callus tissue.
For a thick callus, operate the apparatus in level 2.
After use, turn the switch off.
This appliance is only for household use.
This appliance has direct plug-in type(Listed Power Supply Unit), do not use an extension cord.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated construction.
This foot care system is released in an assembly in which all parts are connected to the
main body. Before use, please familiarize yourself with the instruction describing how
to disassemble and assemble parts.
Open the cover.
Turn the protection shield clockwise to detach it from the main body.
Lift up the abrasive plate vertically to detach it from the callus debris container.
Lift up the callus debris container vertically to detach it from the main body.
Connect the callus debris container to the main body’s motor shaft.
●When connecting to the motor shaft, check for proper direction and then move it
vertically downwards to connect.
●Do not attempt to connect forcefully, this may cause misalignment or separation of
magnet.
Connect the abrasive plate to the callus debris container.
Match the circular protrusion of the main body with that of the protection shied and
then turn the shield counterclockwise for connection to the main body.
Close the cover.
1
2
3
4
1
2
3
4
This appliance has no user serviceable parts.
This appliance should be kept in a place which is safe, dry and out of reach or children.
Handle cord carefully for longer life and avoid jerking, bending sharply, twisting or
straining cord, especially at plug connection.
1
2
3
1
2
3
4
5
6
7
8
9
a
b
c
d

9 8
HOW TO USE
Open the cover.
Plug the adapter into the wall outlet and connect the opposite end to the port of the
main body.
Set the operation level to level 1. ◑
Grip the main body firmly and apply it to the callus for removing the dead callus
tissue.
For a thick callus, operate the apparatus in level 2.
●
After use, turn the switch off.
󳣉
Disconnect the adapter from the port and the outlet.
Turn the protection shield clockwise to detach it from the main body.
Lift up the abrasive plate vertically to detach it from the callus debris container.
Lift up the callus debris container vertically to detach it from the main body.
Remove all debris in the callus debris container.
Turn the container upside down and shake two or three times to easily remove debris.
Frequently clean the container using the supplied cleaning brush.
Refer to‘HOW TO ASSEMBLE’section above for reassembling the apparatus.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
a
b
c
d

11 10
USEFUL TIPS for foot Callus Removal
In order to effectively remove callus, adjust the speed and applied pressure of the
abrasive plate depending on the condition of the callus skin. Use the apparatus in level
1 for a normal case while level 2 is recommended for a severe case.
When the abrasive plate is rotating, apply pressure to reduce its operation speed and
increase the force. If it seems that the callus tissue is not removed properly, attempt to
control the pressure you put on the apparatus.
Keep the higher part of the protection shield towards your face and adjust its angle with
the tip of the main body to prevent debris from flying out towards your face.
Use the apparatus on extended area of the callus and not just one specific spot.
Recommended Procedure.
A. Soak the feet in warm water for about 10~15minutes.
B. Remove excess water and clean with towel.
C. Remove callus with this apparatus.
D. Rinse feet with water.
Apply cream or lotion to the skin after removal of callus tissues to increase
effectiveness.
1
2
3
4
5
6

13 12
PRODUCT INFORMATION PRODUCT WARRANTY & SERVICING
This foot care system is shipped with all components connected to the main body.
Please familiarize yourself with the assembling and disassembling process before use.
For detailed information about this product or questions regarding problem during use,
please contact the distributor.
We warrant this product against defects in materials or workmanship for a period of one year
In order to receive service during the warranty period, you must provide proof of
purchase(for example, bill of sale showing the purchased item and date, product warranty
sheet, etc.) indicating that the service request date is within the warranty period.
The abrasive plate is not covered under warranty due to normal wear.
1
2
3
Damage to products or parts caused by misuse, abuse, negligence or unauthorized alteration
General abrasion and damage including split, scratch, wear out, discoloration and
decoloration.
1
2
Adapter Input Voltage: 100~240Vac
Adapter Input Frequency: 50/60Hz
Adapter Output: 12V, 1 A
Main Body’s Rated Voltage: DC12V
Dimension of the Main Body(inch): 2.8x3.6x2.8(width x height x depth)
PRODUCT SPECIFICATION
WARRANTY EXCEPTIONS
PRODUCT WARRANTY

15
PRODUCT WARRANTY
Product Name
Model Name
Date of Purchase
Purchased from
Telephone
Address
Name of Purchaser
Telephone
Address
Please have the following fields filled in at the time of purchase of this product.