Hoselink 3315 User manual

Instrucons | Version 1.1
Retractable Reel
Hose Repair Kit
Retractable Hose Reel | Models: 3315, 3320, 3325, 3330, 3425, 3515
For more informaon visit www.hoselink.com.au or call 1300 900 617
What you need
Lighter
Secateurs
Pair of Pliers
½ cup of boiling water
Kit contents
1 x plasc double ended barb
2 x easy lock hose clamps
2 x pieces of heat sealing
shrink wrap
Step 1:
Step 2:
Step 3:
Remove the damaged part of the hose, using a pair of
secateurs and ensure each end of the hose is cut square.
Prepare half a cup of boiling water.
Prepare by placing two pieces of heat sealing shrink wrap
and one hose clamp over one end of the hose. Place the
other hose clamp over the other end of the hose.
Step 4:
Submerge the hose end in boiling water to soen, then
repeat with the other end.

For more informaon visit www.hoselink.com.au or call 1300 900 617
Instrucons | Version 1.1
Retractable Reel
Hose Repair Kit
Retractable Hose Reel | Models: 3315, 3320, 3325, 3330, 3425, 3515
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Step 5:
Slide each hose clamp into place and squeeze the hose
clamp with pliers unl it locks automacally (see picture)
Slide the rst piece of heat sealing shrink wrap over the repair.
Use a lighter to apply heat evenly to the shrink wrap. Mak-
ing sure not to leave the ame in one place for too long.
Slide the second piece of heat sealing shrink wrap over the
repair area and repeat the previous step.
Apply full pressure to the hose to test for leaks.
Push one end of the hose on to one side of the double
ended barb and repeat for the other side.
Tip: If the hose is sll quite hard to get over the barb, coat
the barb with dish washing liquid. The slippery surface will
help when pushing the hose on. Holding the middle spacer
with the pliers and twisng the hose can also help.