Operation
Refer to each instruction manual for
detailed uses of the microscope (head
and eyepieces), Full HD camera, USB
CAMERA and so on.
*
２ Place the rubber mat on the table with
the green side up.
Attach the hook and loop fasteners to
the top of the table and the black side
of the rubber mat so that they can stick
together.
Procedures in case of using the ESD rubber mat
The provided rubber mat is a static controlled ESD rubber mat. Use it with
grounding when inspecting electronic components which are sensitive to static
electricity.
１ Remove the stop on the post.
４ Place the stop on the post.
３
Insert the alligator clip into the insulation
cover for protection of electric shock.
Then, attach the socket of the ground cord
to the stud of the rubber mat behind the
post. Finally, connect the insulated*
alligator clip to the ground.
*Cut the cover to the proper length as
needed.
Grounding
３
Stop
Hook and
loop fasteners
・ Secure a ground line for antistatic measures separately from ground lines for motive
power. This could cause a shock.
・ Do not allow live wires to touch the ESD rubber mat. Otherwise, this could cause a
shock.
Warning
