HOZAN L-703 User manual

1
L-703 LED Flex Neck Light
Thank you for purchasing the HOZAN L-703 LED Flex Neck Light. With proper care and
handling, this instrument will provide years of trouble-free operation. Please read this
entire instruction manual carefully before attempting to place this instrument in service.
Please keep this instruction manual avaliable for reference.
INSTRUCTION MANUAL
Identification of parts and contents
Specifications
Flexible arms AC adapter
LED lamps
Diffusion filters
Base plate
Power switch
Brightness adjust knobs
Accessory
White power LED × 2
6500 K
12 VDC (with AC adapter)
5.1 W
Arm length 400mm
425g
90( W)×37(H)×100(D)mm
（With base plate）
90( W)×35(H)×58(D)mm
（Without base plate）
Approx. 10000 hrs.
* Varies according to the environment.
Weight
Dimensions
Main unit
Power consumption
Rated voltage
Color temp.
LED
LED Life
ᴾ
Light brightness (at full power)
1 light
Distance from
light source
(mm)
2 lights
249000*
337000*
81000
126800
35400
38300
11500
14400
*Calculated value
With filter
(lx)
Without filter
(lx)
100
5010050

These symbols are used throughout the instruction manual to alert the user to potential
safety hazards as follows:
… Notice when incorrect handling could cause the user's death or serious
injury.
… Notice when incorrect handling could cause injury to the user or material
damage.
Even if the instructions do not have mark, there are some possibilities
for a serious situation. Follow the instructions.
2
Warning
1. The light source of the LED light emits very bright. Do not look directly at the LED
while it is emitting light. It may damage your eyes.
2. The LED light part becomes high temperature near 60 ℃. Please be careful about
burns.
3. Use the provided AC adapter for power supply
Caution
Warning and caution symbols
Precautions
Operation
Caution
Caution
1Attach the base plate to the Main unit.
Attach to the bottom of the Main unit
with the 4 included flat head screws.
2Connect the AC adapter to a power outlet,
and connect the plug of the AC adapter to the Main unit.
3Turn on the Power switch and operate the Flexible
arms to align the target.
Turn the Brightness adjust knobs to the desired brightness.
ġ
Flat head screws

3
Operation
1-2-12 Saiwaicho, Naniwa-ku, Osaka 556-0021, Japan
Tel : [phone] Fax : [phone]
19.04
Caution
・The Flexible arms are wound springs. If a large force
is applied in the twisting direction (in the direction in
which the winding spring tightens or loosens), it
may cause damage. When changing the pull-out
angle, be sure to stretch it straight once, completely
remove distortion in the twist direction, and pull it
out in the desired direction again.
・Partially sharp bending of the Flexible arms may
cause damage. Bend it so that a large R is attached
to the entire arm. R30mm is the limit. Do not bend
smaller than that.