HP AT-BT10 User manual

AT-BT10 Zip Strap Mount Kit
Installation Guide
0512015-01 | June 2017 1
Introduction
The AT-BT10 Zip Strap Mount Kit includes 25 rubber straps to install your BT10 Series devices to
mobile objects or stationary surfaces.
Refer to the following section for complete installation instructions.
Installing the AT-BT10 Zip Strap Mount Kit
Before installing your AT-BT10 Zip Strap, ensure that the installation location does not come into
contact with other objects that may cause damage to this mount or the device.
1. Insert the BT-10 device into the strap by pressing it into the housing. See Figure 1.
Figure 1 Inserting the device into the mount
2. Activate the device, insert a coin into the indention located at the center of the rear panel, then
turn clockwise until the indicator arrow is aligned with the “I” marking. See Figure 2.
Figure 2 Activating the AT-BT10
3. Insert the small end of the strap into the locking slot located on the opposite end and pull to
tighten. See Figure 3.

2AT-BT10 Zip Strap Mount Kit | Installation Guide
Figure 3 Tightening the mount strap
© Copyright 2017 Hewlett Packard Enterprise Development LP