HP Enterprise OfficeConnect 1405 v3 Series User manual

HPE OfficeConnect 1405 v3 Switch
Series
Quick Setup Guide
The information in this document is subject to change without notice.
© Copyright 2016 Hewlett Packard Enterprise Development LP
Part number: 5200-0803
Hewlett Packard Enterprise 3000 Hanover Street Palo Alto, CA 94304
5200-0803

1
Product list
Table 1 Product list
Product
code Description Alias RMN
JH407A HPE OfficeConnect
1405 5G v3 Switch HPE 1405 5G v3 Switch HNGZA-HA 0030
JH408A HPE OfficeConnect
1405 8G v3 Switch HPE 1405 8G v3 Switch HNGZA-HA 0031
Installation tools and accessories
Figure 1 Installation tools (user supplied)
Figure 2 Installation accessories (provided)
Phillips
screwdriver ESD wrist strap
Wall mounting kit

2
Installing the switch
CAUTION:
Before installation, wear an ESD wrist strap, and make sure the
wrist trap has good skin contact and is reliably grounded.
The procedures for installing the HPE 1405 5G v3 Switch and the
HPE 1405 8G v3 Switch are the same. This section uses the HPE
1405 5G v3 Switch as an example.
Horizontal surface mounting
Place the switch upside up on the workbench.
Wall mounting
The HPE 1405 5G v3 Switch and HPE 1405 8G v3 Switch can be
installed on a wall. The installation hole spacing varies by switch
model, as shown in Table 2.

3
Table 2 Installation hole spacing for each model
Chassis Installation hole spacing
HPE 1405 5G v3 Switch 74 mm (2.91 in)
HPE 1405 8G v3 Switch 102 mm (4.02 in)
To install the switch on a wall:
1. Drill two holes at the same height.
2. Insert one wall anchor into each hole until the anchors are flush
with the wall surface. Drive one screw into each wall anchor,
and then tighten the screws just enough to keep it secure in the
wall anchor.
3. Align the two mounting holes in the switch chassis bottom with
the two screws on the wall and hang the switch.

4
NOTE:
For wall mounting, the network ports can face upwards or
downwards.
Under-table mounting
WARNING!
•Make sure the table is sturdy enough to support the weight
of the switch and attached cables.
•Ensure good ventilation to prevent overheating.
The HPE 1405 5G v3 Switch and HPE 1405 8G v3 Switch can be
installed under a table. The installation hole spacing varies by switch
model, as shown in Table 2.

5
After installation, install the securing screw (included in the kit) to
prevent switch movement.
Connecting the power adapter
WARNING!
To avoid bodily injury, first connect the power adapter to the
switch and then to the power supply system.
Mounting slots
74mm(2.91 in)
Wood table
Third securing screw

6
Connecting network cables
Documentation
To access documentation and support services, go to the Hewlett
Packard Enterprise Support Center website:
www.hpe.com/support/hpesc