HUBBELL LIGHTING BEACON ORBEON User manual

ORBEON INSTALLATION INSTRUCTIONS
READ THOROUGHLY BEFORE INSTALLING
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Cole and all local
codes. Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH.
Install and use so xture failures do not cause a hazard and use only in environments for which the product is
specically marked.
WARNING! This product contains chemicals know to the State of California to cause cancer, birth defects, and/
or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this
product.
CAUTION! Follow ALL luminaire and control recommendations, product markings, instructions, restrictions and
warnings regarding luminaire operation and burning position. Luminaire label shows electrical and environmental
requirements and restrictions.
All electrical work must be done by a qualied electrician.
Turn o electric power to all aected circuits and allow to cool before servicing.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting
any work, contact your Hubbell Lighting distributor or [email protected] or [phone].
Give instructions to facility owner/manager for future reference.
INSTALLATION INSTRUCTIONS FOR ORBEON CEILING MOUNTED LED LUMINAIRE
CAUTION HIGH VOLTAGE
LIGHT FIXTURES AND WIRING SHOULD BE SERVICED BY A QUALIFIED ELECTRICIAN

ORBEON INSTALLATION INSTRUCTIONS page 2
WARNING:TO AVOID DAMAGE TO LED LAMPS, AC POWER SUPPLY MUST BE TURNED OFF BEFORE
CONNECTING OR DISCONNECTING SECONDARY WIRING CONNECTIONS.
INSTRUCTIONS: (ENSURE THAT POWER IS TURNED OFF)
1. Verify that input power is 120-277 VAC.
2. Loosen Phillips screw that holds the bracket to the housing. Remove bracket from Orbeon housing.
3. If provided with the optional bird guard, secure bracket to the housing using screws provided.
4. Attach the mounting bracket to the junction box (by others) using screws (by others). Junction box may
be recessed (as shown), surface mounted or suspended. Assure bracket is square with trac for aesthetics.
Observe “street side” label if directional optics are provided. Street side label should be mounted to match the
direction of trac ow.
Ceiling Surface
Conduits and Primary
Wiring (by others)
Concrete
(by others)
2
4
Mounting Bracket
.75
3.5
2.75
1.75
6.0
Screw Bird Guard
Align the guard such that this
notch is opposite of the screw
3

ORBEON INSTALLATION INSTRUCTIONS page 3
9. Turn the power on and test.
8. Tighten the Phillips screw loosened in step 2 to secure
the Orbeon housing.
5. Hook the Orbeon housing on to the bracket.
6. Connect the power leads supplied on Orbeon to the
power leads in the junction box.
7. Rotate the Orbeon housing upwards to close the xture.
Stu wiring into junction box. 5
7
6
Connect Leads
Orbeon LED
Housing
8
Junction Box (by others)
5
Generic Model
Details May Vary
9