HUBBELL LIGHTING COMPASS CU2FO User manual

WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Hubbell Lighting, Inc. Life Safety Products • www.compasslightingproducts.com
Copyright© Hubbell Lighting, Inc., All Rights Reserved • Specications subject to change without notice. • Printed in U.S.A.
COM604073_INST_SHT 11/17
Fixed Optic LED Emergency Light
CU2FO
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Equipment should be mounted in locations at heights (Max: 9ft) where it will not be subject
to tampering by unauthorized personnel.
3. Do not mount near gas or electric heaters
4. The use of accessories are not recommended by the manufacturer and may cause an
unsafe condition.
5. Do not use this equipment for other than its intended use.
6. Servicing of this equipment should be performed by qualied personnel.
7. Disconnect AC power before servicing.
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
IMPORTANT
The battery in this unit may not be fully charged. After electricity is connected to the unit,
let battery charge up to 24 hours. Then the normal operation of this unit should take
effect. To check press the “TEST” button and the lights on the unit should turn ON
RECYCLING INFORMATION
All steel, aluminum and thermoplastic
parts are recyclable. All cartons contain
recycled materials.
Please recycle responsibly.

INSTALLATION
WIRING DIAGRAM
Warning:
Unused wires must be capped
using enclosed wire nuts.
Fig. A Fig. B Fig. C
J-Box Mounting
1. Feed xture leads through back plate and connect AC power supply (Fig. A).
2. Connect wires through J-box. Secure back plate on to J-Box with screws.
3. Connect battery before AC power can be provided to the unit (Fig. B).
4. Align snaps and push housing directly onto back plate (Fig. C). Supply AC power and press
“TEST” button to check light.
Conduit Mounting
5. Secure back plate to wall surface. Route wires through hole in conduit ange and make conduit
connection.
6. Connect battery before AC power can be provided to the unit (Fig. B).
7. Align snaps and push housing directly onto back plate (Fig. C). Supply AC power and press
“TEST” button to check light.
OPERATION
1. During an electrical power failure, the lamps will automatically illuminate for a minimum of 90
minutes.
2. To test, pust the “TEST” switch. The emergency lamps will illuminate. When the switch is
released, the lamps will go off.
3. LED light is on when AC power & battery connected.
4. LED light will be OFF when AC power is disconnected.
5. LED light will be OFF when battery is disconnected or damaged