Human Solution turnstone bivi User manual

Installation Instructions
©2011 Steelcase Inc.
Printed in U.S.A. 939500449 Rev C
Page 1 of 20
*table with back pocket
*electrical
bivi™
*table

myturnstone.com/bivi/instructions
Assembly time:
20 Minutes
really
easy a little more difficult
leg
Time Needed
Difficulty Scale
Assembly Video
Tools Needed Here's what's in the boxes
table top
electrical trough table top with back pocket
939500449 Rev C
Page 2 of 20
(included)

pocket cover trough end caps
939500449 Rev C
Page 3 of 20
For assembly video, go to myturnstone.com/bivi/instructions
right and left brackets
thumb screws
back pocket

939500449 Rev C
Page 4 of 20
Assemble
leg.
STEP
1
(a)
tip
Use packaging foam
for assembly fixture.
ALIGN ROUND
“TOP” LABELS.
• Pull off covers (a).
• Install leg onto supports with four cap screws.
Screws must be securely tightened with no gaps
between the parts.Recommend tightening screws
to 66-72 in-lbs (b).
• Install opposite leg same as previous step (c).
• Snap on covers (d).
(a)
(b)
(c)
(d)
(d)

939500449 Rev C
Page 5 of 20
STEP
2
Stage trough.
• Set the trough between the two legs
on a clean surface.

939500449 Rev C
Page 6 of 20
Attach leg
to trough.
STEP
3
• Stand one leg up.
• Lift and place end of electrical trough up
to the leg.
• Drop the lip of the trough into the slot on
the leg (a).
• Make sure the connection bracket is fully
engaged with the top leg slot (b).
• Tighten with hex wrench (c).
(a)
(b) (c)
tips
Rest one side
of the trough
on the floor and
place lip on the
other side into
the bottom edge
of the leg.
View from underneath.
lip

939500449 Rev C
Page 7 of 20
STEP
4
• Remember what you did a few
minutes ago? Do that again.
Install
second leg.
NOTE: If you just want an individual table, place trough to far end.
Proceed with following steps.

939500449 Rev C
Page 8 of 20
Attach
STEP
5
• Attach the brackets into the slot in the leg top
and rotate (a).
• Push the bracket back toward the electrical
trough to complete the attachment (b).
worksurface
brackets.
(a) (b)

939500449 Rev C
Page 9 of 20
Add
electrical.
STEP
6
• Insert the cord of power strip #1 into the
power cutout in the trough that is closest to
the power outlet.
• Continue to insert power strips #2, #3 & #4.
The cords from each power strip should be
hanging to the floor.
tips
For more in depth
resources of the
electrical, visit
myturnstone.com
electrical section
or see assembly
instructions sent
in electrical box.

939500449 Rev C
Page 10 of 20
STEP
7
Install knobs.
• Install the knobs, two per power strip,
inside the trough and onto the bottom of
the power strip at each end.
View from underneath trough.