HumanCentric 101-2100 User manual

Model 101-2100
www.humancentric.com/patents
Mac StudioTM Under Desk Mount
© 2023 HumanCentric Ventures LLC www.humancentric.com
PARTS INCLUDED
ADDITIONAL TOOLS REQUIRED
Phillips Screw Driver
Drill
1/8” Drill Bit
A (x1)
Mounting Bracket
WARNING
To reduce the risk of injury to persons, read all important precautions and warnings listed below. HumanCentric
assumes no responsibility for personal injury or property damage sustained by or through the use of this product:
Read all instructions carefully.
Incorrect installation may lead to damages or serious injury. Ensure the product is secured before use.
Do not install on desks less than ¾” thick.
1.
2.
3.
B (x4)
M4 x 19mm Wood Screw
C(x2)
Cable Tie
Full product specifications: www.humancentric.com/101-2100
Need help? Contact support: [email protected]

1
Warning: Do not install on desks less than ¾” thick
Position bracket in desired location underneath the desk with the oset cutout towards the back.
Using the bracket as a guide, mark and drill four holes using a 1/8” drill bit. Make sure to not drill all
the way through the desktop.
> 3/4”
< 3/4”
A
USE 1/8” DRILL BIT
Tip: Use a piece of tape on the drill bit ½” from
the tip to ensure the correct drill depth.
© 2023 HumanCentric Ventures LLC www.humancentric.com

4
2
2
Screw the bracket into the bottom of the desk using the four M4x19mm wood screws (B).
2
3
Place the Mac Studio into the bracket from the front and rest it in the circular cutout.
Warning: Do not slide the Mac Studio against the bracket side walls during installation.
B
© 2023 HumanCentric Ventures LLC www.humancentric.com