Humminbird PIRANHAMAX 4 User manual

PIRANHAMAX 4 TRANSDUCER
Install Guide
WB.TD.01
https://support.legendboats.com/ 1
Ensure the proper template is selected for the Piranhamax 4 transducer and Boat model.
ATTENTION
TOOLS REQUIRED INSTALL GUIDE
9/64” Drill Bit
Tape Measure
Transducer
Template
Silicone
Drill
Safety Glasses
Phillips Bit

PIRANHAMAX 4 TRANSDUCER
Install Guide
WB.TD.01
https://support.legendboats.com/
2
Arrange all parts and hardware to begin
installing the Transducer.
STEP 1
STEP 2
STEP 3
Assemble the Transducer onto the Mounting
Bracket.
Using the proper Transducer Template, mark
the installation location of the Mounting
Bracket 12in from the Keel.
Using a 9/64” Drill bit, drill a pilot hole into
the Transom approximately 1” into the Hull.
The template should be 12 inches from the Keel.
ATTENTION
Refer to the supplied manufacturer’s instructions
for full assembly steps.
NOTE
12”
Ensure no cords or fuel separator are at risk
of being drilled into. Some models will require
carpeting/flotation foam to be removed before
drilling into the hull.
ATTENTION

PIRANHAMAX 4 TRANSDUCER
Install Guide
WB.TD.01
https://support.legendboats.com/ 3
STEP 4
STEP 5
STEP 6
Using marine grade Silicone, seal the pilot
holes prior to installing the Mounting
Bracket.
Using the supplied hardware, install the
Mounting Bracket onto the Transom.
Mount the transducer in the highest position.
Route the Transducer wire vertically along
the transom, marking the location of each
wire clip.
Drill into the Transom, apply silicone and
install the Wire Clips into the Transom.