Hunter HEPAtech 30057 User manual

41557-01 01/31/2007 ©2007 Hunter Fan Company
HEPAtech®
Air Purification System
Air Purifier Model HEPAtech®Filter Pre-Filters
30057A 30928 30901
30067A, 30124A 30928 30901
www.hunterfan.com
Model 30067A, 30124A, 30124AModel 30057A
ENGLISH
Page 2 ESPAÑOL
Página 9 FRANÇAIS
Page 17

2
®
41557-01 01/31/2007 ©2007 Hunter Fan Company
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS AIR PURIFIER
AND SAVE THESE IMPORTANT INSTRUCTIONS
1. This Air Purifier is designed for use on a flat, level surface and may not work
properly on an uneven surface. ALWAYS place this Air Purifier on a firm, level
surface. ALWAYS place the Air Purifier at least six (6) inches away from
walls and heat sources such as stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out of the reach of children.
3. Before using the Air Purifier, extend the cord and inspect for any signs of dam-
age. DO NOT use the product if the cord has been damaged.
4. This product has a polarized plug (one blade is wider than the other) as a safety
feature. This plug will fit into a polarized outlet only one way. If the plug does
not fit fully into the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. DO NOT attempt to defeat or override this safety feature.
5. ALWAYS UNPLUG the Air Purifier when it is not in operation, while the filter
is being changed, and while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it is in operation. Shut off and
unplug before moving.
7. DO NOT immerse the Air Purifier in water as permanent damage will occur.
Refer to and follow the CLEANING AND FILTER REPLACEMENT in-
structions.
Introduction
Thank you for purchasing the HEPAtech®Air Purification System from Hunter Fan
Company. You have purchased our latest development in portable Air Purification
Systems. This system has been developed to improve the quality of the air you breathe.
Our HEPAtech®Air Purification System out performs other air purification systems
by quickly and effectively removing dust, smoke, and pollen particles as small as .1
microns in size. Room air is pulled in through the front grill and cleaned across the
HEPAtech®filter. Clean air is then released out the top grill in order to avoid stirring
up settled particles.
Using the Ionizer
Using the ionizer improves the quality of air in the room. Negative ions are released
into the air and positively charged dust, smoke, and pollen particles are attracted to
the negative ions. These particles settle out of the air and can be vacuumed up dur-
ing normal cleaning. These particles are also more easily captured by the HEPAtech®
filter as they pass through the HEPAtech®Air Purification System. To ensure the best
air circulation in the room, we recommend that you place your air purifier six inches
away from any walls.

3
®
©2007 Hunter Fan Company 01/31/2007
Setting Up Your Air Purifier
1. Remove your air purifier from the box and take it out of the clear plastic protective bag.
2. Place your HEPAtech®Air Purifier on a firm, flat floor.
3. Before turning the Air Purifier ‘on,’ open the front grill.
• For Model 30057A: To release the front grill, press the buttons on the side until
the front grill slides easily over the buttons. (Refer to Figure 1.)
• For Model 30067A, 30124A: To release the front grill, place your fingers
behind the tabs and pull forward. (Refer to Figure 2.)
4. Next, check the HEPAtech®filter by pressing firmly on all four corners of the filter
to ensure that it is fully inserted into the filter opening.
5. The carbon pre-filter is mounted inside of the front grill with “hook” tape. Con-
firm that it covers the grill vents. (Refer to Figure 3.)
6. Place the filter installation reminder sticker on the inside edge of the front grill. Circle
the month and write the year of installation for the pre-filter and HEPAtech®filter.
7. Replace the filter and front grill. Be sure that the bottom grill tabs are in position
first, and then push the top of the grill forward until it is closed. The unit is now
ready for normal operation. NOTE: This unit will not operate unless the door is
placed in the correct position.
8. Plug the unit into a 120V electrical outlet.
AIR PURIFIER PARTS
Figure 1 - Model 30057A
Tabs for
opening the
front grill
HEPAtech®
Filter
Pre-Filter
Front
Grill
Figure 2 - Model 30067A, 30124A
Figure 3
Hook Tape
Grill Vents
Hook Tape
Front
Grill
Pre-Filter
HEPAtech®
Filter
Buttons for
opening the
front grill

4
®
41557-01 01/31/2007 ©2007 Hunter Fan Company
Operating Your Air Purifier
On/Speed Control: Rotate the Speed Control knob to set the desired speed. A set-
ting of zero (0) indicates that the unit is off, one (1) is low speed, two (2) is medium
speed, and three (3) is high speed. The fan speed can be adjusted at any time.
Ionizer: Press this button to turn ‘on’ the ionizer. When the ionizer is ‘on’, the green
light near the button will be illuminated.
Pre-Filter and Filter Timers
This air purifier contains timers that indicate when the pre-filter and filter should
be changed. The timer automatically counts the number of hours that each filter has
been in use. When the pre-filter counter reaches 1400 hours (approximately three
months of use), the pre-filter indicator will be lit to show that the pre-filter should be
changed. When the HEPAtech®filter counter reaches 2800 hours (approximately four
to six months of use), the HEPAtech®filter indicator will be lit to indicate that the
filter should be changed. The exact life of the pre-filter and filter will depend upon the
environment. If necessary, the filters should be changed more frequently.
To reset the pre-filter or filter timers when one indicator (or both) is lit:
1. Change the filter and/or pre-filter as described in the Maintenance section of
the manual.
2. To reset the counter to zero hours and turn off the indicator, simply press and hold
the filter reset key for three seconds. If both the pre-filter and filter indicators are
lit, the reset key will first turn off the pre-filter indicator. Then, you must release
the reset key and then press and hold the filter reset key again for three seconds to
turn off the filter indicator.
To reset the pre-filter or filter timers before the indicators are lit:
In some environments, you may want to change the pre-filter or filter more frequently
than indicated by the filter indicators. This procedure allows you to reset the pre-filter
or filter counter before the indicators are lit.
1. Change the filter and/or pre-filter as described in the Maintenance section of
the manual.
2. Now, you must choose which timer you want to reset. Press and hold the filter
reset key (approximately three seconds) until the pre-filter indicator flashes. Press
the reset key again to alternate between the two indicators. The timer that will be
reset is designated by the flashing indicator.
3. Once you have the correct indicator flashing, press and hold the reset key for three
seconds to reset that timer to zero hours. The indicator will stop flashing when it
has been reset. If needed, repeat these steps to reset the other timer.

5
®
©2007 Hunter Fan Company 01/31/2007
Cleaning and Filter Replacement
1. Clean the outside of the unit with a soft, damp cloth. The front grill can be removed
and cleaned in soapy water. Remove the pre-filter before cleaning the front grill.
2. At least every 90 days, replace the carbon pre-filter. This is necessary to main-
tain proper odor removing and overall filtration performance. If necessary, it can
be changed more often. Mark the new filter installation sticker included with the
new carbon pre-filter. Be sure to remove any plastic wrapping that may be on
the new filter before you place it in the Air Purifier.
3. While replacing the pre-filter, you should view the condition of the HEPAtech®
Filter. Compare the filter to the color coded chart that is on the inside of the hous-
ing. If the filter matches the dark color on the chart, you should remove the filter
and replace it with a new filter. Mark the new filter installation sticker included
with the new HEPAtech®Filter. Depending on use and environment, the
HEPAtech®Filter should last four to six months.
4. Gently pull on the filter to remove it from the unit. While removing the filter, note
the directional arrows printed on the top of the filter. The new filter will be in-
stalled with the same orientation. Once removed, the used filter can be discarded.
5. Remove the new filter from its wrapping and look at the directional arrows printed
on the side of the filter. Install the filter with arrows pointing towards the unit.
Press the filter firmly into the air purifier. To avoid damaging the filter media, you
should press on the frame of the filter only.
6. If you notice a decrease in air output or an increase in noise, the HEPAtech®Filter
may be clogged. Replace it with a new HEPAtech®Filter.
Replacement Filters
To obtain a replacement filter for your Air Purifier, call 1-800-4Hunter for
your nearest retailer or Hunter Customer Service at (US) 1-888-830-1326,
(Canada) 1-888-855-8300. Please be prepared to tell the operator the model
number of your Air Purifier and the model number of the filter you need to re-
place. Visit our website at www.hunterfan.com.
Hunter Air Purifier Model No.: 30057A 30067A, 30124A
Pre-Filter Replacement Model No.: 30901 30901 30901
HEPAtech®Filter Replacement Model No.: 30928 30928 30928

6
®
41557-01 01/31/2007 ©2007 Hunter Fan Company
How the HEPAtech®Air Purification System Works
As the air is pulled into the purifier, the activated carbon pre-filter absorbs odors and
catches large particles. Then, the air travels through the HEPAtech®filter where the
smaller particles are collected. Then, the ionizer releases negative ions into the air that
attract positively charged dust, smoke, and pollen particles. Finally, the clean, purified
air is released back into the room.
Other Home Comfort Products from Hunter
To learn more about Hunter Fan Company products,
please see our Web page at:
www.hunterfan.com
Hunter Original®Programmable
Thermostat
The Care-Free
Humidifier™
Carbon
Pre-Filter
HEPAtech
®Filter
99.97% – .1 Microns
Dust & Irritants Pollen & Allergens Odors Bacteria Pet Hair & Dander
Ionizer

7
®
©2007 Hunter Fan Company 01/31/2007
Hunter Fan Company
HEPAtech®Air Purification System
5 YEAR LIMITED WARRANTY
The Hunter Fan Company makes the following limited warranty to the original residential
user or consumer purchaser of the HEPAtech®Air Purification System:
If any part of your HEPAtech®Air Purification System (“Air Purifier”) motor fails dur-
ing the first five (5) years from the date of installation to you due to a defect in material
or workmanship, we will provide a replacement Air Purifier free of charge. Installation is
deemed to occur at the date if purchase.
If the Air Purifier cord, ionizer, or front grill fails any time within one (1) year after instal-
lation due to a defect in material or workmanship, we will replace or, at our option, repair
the unit free of charge at our nearest service centre or at our Service Department in Mem-
phis, Tennessee. You will be responsible for all parts and labour costs after this one-year
period.
USE OF A NON-HUNTER FILTER WILL INVALIDATE THIS WARRANTY. IF THE
ORIGINAL RESIDENTIAL USER OR CONSUMER PURCHASER CEASES TO
OWN THE AIR PURIFIER, THIS WARRANTY AND ANY IMPLIED WARRANTY
WHICH THEN REMAINS IN EFFECT, INCLUDING BUT NOT LIMITED TO
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PAR-
TICULAR PURPOSE, ARE VOIDED.
NO WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS MADE IN
RESPECT TO THE FILTER MATERIAL OR CARBON FILTER.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. THE
DURATION OF ANY IMPLIED WARRANTY INCLUDING BUT NOT LIMITED
TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, IN RESPECT TO THE MOTOR IS EXPRESSLY LIMITED
TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE.
This warranty is voided if the air purifier is not purchased and used in the USA or Canada.
This warranty excludes and does not cover defects, malfunctions or failures of the Air
Purifier which were caused by repairs by persons not authorized by us, use of parts or ac-
cessories not authorized by us, mishandling, modifications, or damage to the Air Purifier
while in your possession, or unreasonable use, including failure to provide reasonable and
necessary maintenance. This warranty does not cover Air Purifiers used in commercial ap-
plications. There are no express or implied warranties as to commercial purchasers or users.
To obtain service, contact the nearest Hunter authorized service centre or the Hunter Fan
Company Service Department, 2500 Frisco Avenue, Memphis, Tennessee 38114, 888-830-
1326 (U.S.) or 888-855-8300 (Canada). For the name of our nearest authorized Hunter
Fan Company Service Centre, write to the Hunter Fan Company at the preceding address.
(Continued)

8
®
41557-01 01/31/2007 ©2007 Hunter Fan Company
Hunter Fan Company
2500 Frisco Avenue
Memphis, Tennessee 38114
USA
Printed in China & Taiwan
®
You will be responsible for insurance and freight or other transportation to our factory
service center. We will return the Air Purifier freight prepaid. The Air Purifier should be
properly packaged to avoid damage in transit since we will not be responsible for any such
damage. Proof of purchase is required when requesting warranty service. The purchaser
must present sales receipt or other document that establishes proof of purchase.
IN NO EVENT SHALL HUNTER FAN COMPANY BE LIABLE FOR DIRECT, IN-
DIRECT, SPECIAL CONSEQUENTIAL OR INCIDENTAL DAMAGES IN EXCESS
OF THE PURCHASE PRICE OF THE AIR PURIFIER. YOUR SOLE REMEDY WILL
BE REPAIR OR REPLACEMENT AS PROVIDED ABOVE.
SOME AMERICAN STATES AND CANADIAN PROVINCES DO NOT ALLOW:
• LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS;
• THE EXCLUSION OR LIMITATION OF DIRECT, INDIRECT SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES;
SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR PROVINCE
TO PROVINCE.