Hunter QuietFlo 36114 User manual

41481 10-5-2001 © 2001 Hunter Fan Company
®
SINCE 1886
TM
QuietFlo
Filter
Pre-FilterFilter
Reset
012
3
True HEPA Air Purifier
Models 36259 & 36260 Models 36394 & 36395
QuietFlo
0
1
23
Models 36114 & 36115
QuietFlo
Filter
Pre-FilterFilter
Reset
012
3
Models 36144 & 36145
EnglishSpanishGermanFrenchItalianDanishDutchPortuguese

241481-01 10-5-2001
®
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS AIR PURIFIER.
1. This Air Purifier is designed for use on a flat, level surface and
may not work properly on an uneven surface. ALWAYS place
this Air Purifier on a firm, level surface. ALWAYS place the Air
Purifier at least six (6) inches away from walls and heat sources
such as stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out of the reach of
children.
3. Before using the Air Purifier, extend the cord and inspect for
any signs of damage. If the supply cord is damaged, it must be
replaced by a manufacturer or its service agent or similarly
qualified person in order to avoid hazard.
4. If the plugdoesnotfit fullyand securelyinto theoutlet, reverse
the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to use the unit unless the plug fits securely
into the socket.
5. ALWAYS UNPLUG the Air Purifier when it is not in operation,
while the filter is being changed, or while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it is in operation.
Shut off and unplug before moving.
7. DO NOT immerse the Air Purifier in water, as permanent
damage will occur. Refer to and follow the AIR PURIFIER
MAINTENANCE instructions.
READ AND SAVE ALL INSTRUCTIONS.
English

41481-01 10-5-2001 3
®
INTRODUCTION
ThankyouforpurchasingtheQuietFlo™TrueHEPAAirPurifierfromHunter
Fan Company. You have purchased our latest development in portable
Air Purification Systems. This system has been developed to improve the
quality of the air you breathe.
Our QuietFlo™ True HEPA Air Purifier out performs other air purification
systems by quickly and effectively removing dust, smoke, and pollen
particles. The HEPA filter will remove 99.97% of particles 0.3 microns in
size from air that passes through the filter.
The activated carbon pre-filter helps remove cooking, smoke, and pet
odors from the air. It also traps lint, hair, and large particles, which helps
improve the life and performance of the HEPA filter.
HOW THE QUIETFLO™ HEPA AIR PURIFIER WORKS
Asthe air is pulledinto the purifier, the activated carbon pre-filterabsorbs
odors and catches large particles. Then, the air travels through the HEPA
filter where the smaller particles are collected. Finally, the clean purified
air is released back into the room.
Figure 1- Illustration of the Air Filtration System
Dust & Irritants Pollen & Allergies Odors Bacteria Pet Hair & Dander
Carbon
Pre-filter True HEPA Filter 99.97% -- .3 Microns
English

441481-01 10-5-2001
®
SETTING UP YOUR AIR PURIFIER
1. Remove your air purifier from the box and take it out of the clear
plastic protective bag.
2. Place your QuietFlo™ Air Purifier on a firm, flat surface.
3. Before turning the Air Purifier ON, you need to open the front grille.
For Models 36114/36115/36144/36145: To release the front grille,
press the tabs until the front grille slides easily over the tabs. Refer to
Figures 2a on page 5.
For Models 36259/36260/36394/36395: To release the front grille,
place your fingers behind the tabs and pull forward. Refer to Figures
3a and 3b on page 6.
4. The HEPA filter is already installed, but you should confirm that it has
not shifted during shipment. Check the position of the HEPA filter
by pressing firmly on all four corners to ensure that it is fully inserted
into the filter opening.
5. The carbon pre-filter is mounted inside the front grille with hook
tape. Confirm that it covers the grille vents. Refer to Figures 2b, 3c,
and 3d on pages 5 and 6.
6. Find the filter installation reminder sticker on the inside edge of the
front grille or unit. Circle the month and write the year of installation
for the pre-filter and HEPA filter.
7. Replace the front grille. Be sure that the bottom grille tabs are in
position first, and then push the top of the grille forward until it is
closed. The unit is now ready for normal operation.
Note:Theunit will not operate unlessthedoor is placed in thecorrect
position.
8. Plug the unit into the proper voltage outlet
RatingHunter Model No.
36114
36144
36259
36394
36115
36145
36260
36395
120 V 60 Hz
220-240 V 50 Hz
English

41481-01 10-5-2001 5
®
QuietFlo
0
1
23
Figure 2a - Models 36114 & 36115
Figure 2b - Models 36114, 36115, 36144 & 36145
Front Grille
Pre-filter
HEPA Filter
Press to
Open
Front Grille
Hook Tape
Inside View of
Front Grille
Grille Vents
Hook Tape
Tab
English