Husky CN215 User manual

Husky CN215 Dual-Zone
Slimline Wine Cooler
Owner Manual
To ensure safe operation, please read this instruction manual thoroughly before use.
ENGLISH
For illustration only. Stock not included.
THIS APPLIANCE IS TO BE USED EXCLUSIVELY FOR THE STORAGE OF WINE

Welcome to your new Husky
Thank you for buying this Husky Wine Cooler. It has been designed and
manufactured for years of trouble-free service.
Operation is very simple, but please take a few minutes to read this booklet.
It contains important safety information, and tips to ensure you receive the
best possible service from your Husky Wine Cooler.
IMPORTANT NOTE: THIS APPLIANCE IS TO BE USED EXCLUSIVELY FOR
THE STORAGE OF WINE. This Husky Wine Cooler uses thermoelectric
technology to cool drinks to approximately 15°C below ambient temp-
erature, to a minimum of 7°C. It is not intended to operate like, or
compete with, a conventional compressor-driven refrigerator.
THIS MODEL IS NOT SUITABLE FOR THE STORAGE OF FOOD.
WARNING: RISK OF ELECTRICAL SHOCK HAZARD
USERS IN EUROPE This unit must be earthed.
If the power cable is damaged, it must be replaced by a qualified engineer
to avoid shock hazard. DO NOT ATTEMPT TO SERVICE THE ITEM YOURSELF. Ensure
that the appliance is properly earthed. Stop using the appliance immediately
if electric shock is felt when touching the cooler.
DISPOSAL OF OLD REFRIGERATORS
BE SURE TO MAKE ANY LOCKS UNUSABLE. IF POSSIBLE, REMOVE THE
DOOR(S) AND DISCARD SEPARATELY.
WARNING – CHEMICAL HAZARD: DO NOT ALLOW CHILDREN TO PLAY WITH
THE OLD APPLIANCE. CONTACT YOUR LOCAL AUTHORITY FOR PROPER
DISPOSAL PROCEDURES.
Before disposing of an old appliance, please make sure it is switched off and
safe. Unplug the appliance and break any locks in order to avoid children
becoming trapped.
Please note: the cooling system contains gases and refrigerants which
require specialist waste disposal. The valuable materials contained in a
refrigerator can be recycled.
Contact your local waste disposal depot for proper disposal of an old
appliance and contact your local authority or dealer if you have any questions.
Please ensure the pipework of your cooler is not damaged prior to disposal.
You can contribute to environmental awareness by insisting on an appropriate
non-polluting method of disposal.
DISPOSAL OF PACKAGING
All the packaging materials with your Husky Wine Cooler may be disposed of
without danger to the environment.
The cardboard may be broken or cut into smaller pieces and given to a waste
paper disposal service. The wrapping foil is made of polyethylene. The
polyethylene pads and stuffing contain no fluorochloric hydrocarbons.
All these valuable materials may be taken to a waste collecting depot and
used again after adequate recycling.
Consult your local authority for the name and address of the waste paper
disposal services nearest to you.
2 HUSKY DUAL-ZONE SLIMLINE WINE COOLER

HUSKY DUAL-ZONE SLIMLINE WINE COOLER 3
SAFETY INSTRUCTION & WARNINGS
Before switching on your Husky Wine Cooler, read the information in this User
Guide carefully. The User Guide contains important observa tions relating to
the assembly, operation and maintenance of the appliance.
Please keep this booklet in a safe place for future reference. If you ever sell
this unit, hand this User Guide to the new owner.
The manufacturer does not accept responsibility for any damages that may
arise due to non-observation of these instructions.
WARNING: When positioning the appliance ensure the supply cord is not
trapped or damaged. Do not locate extension sockets or charging
transformers/power supplies adjacent to the compressor at the back of
the unit, as they could overheat.
• Do not use damaged appliances. If you are in any doubt, consult the
supplier.
• Connection and installation of the unit is to be carried out in strict
compliance with the relative instructions in this User Guide.
• For safety, the appliance must be properly earthed in accordance
with specifications.
• Always remember to unplug the appliance before cleaning. Never
unplug your cooler by pulling on the power cable. Always grip plug
firmly and pull straight out from the socket.
• All electrical repairs must be carried out by qualified engineers.
Inadequate repairs may be dangerous.
• DANGER OF FERMENTATION: Keep alcoholic beverages in airtight
bottles or containers.
• Do not damage any parts of the appliance which carry refrigerant by
piercing, perforating, crushing, twisting or scraping. If the refrigerant
comes into contact with the eyes, it may cause serious eye injury.
• Do not obstruct or cover the ventilation aperture.
• Do not allow children to play with your Husky Wine Cooler, or to sit
on it or hang onto the door.
• This appliance is not intended for used by persons (including
children) with reduced physical, sensory or mental capabil ities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
SPECIFICATIONS
• This appliance is designed as a cooler for wine, NOT food.
• It is intended strictly for domestic use.
BEFORE USING FOR THE FIRST TIME
• For good circulation, the vents must not be blocked. Allow 50mm
clear space all round the unit for adequate ventilation. Your Husky
Wine Cooler should be placed on flat and firm surface for quieter
operation. If the appliance is to be placed on carpet, support it with
a wooden board underneath. Be aware that placing the appliance on
carpet may cause the carpet to fade.

• Do not expose the appliance to direct sunlight or a heat source such
as ovens, radiators, heaters, etc.
• Do not under any circumstances place heated beverages or food in
your Husky Wine Cooler.
• Do not open the door more often than necessary to lessen the
escape of cold air.
• For better air circulation, do not overfill the unit.
• Adjust the temperature regulator according to the amount of product
and the ambient temperature.
HUS-CN215 HANDLE ASSEMBLY INSTRUCTIONS
These instructions are for fitting the handle on your CN215 Wine Cooler.
When opening the box, you can see that the handle is not assembled onto
the wine cooler to avoid damage during transportation. You will see two
screws holes reserved for the fixing of the handle on the door panel.
• Please open the door, take the handle part and screws stored in the
cavity for transportation.
• Carefully remove the magnetic seal and find the opposite end of the
two screw holes.
• Insert the screws until the tip can be seen on the other end on the
front door panel.
• Position the handle in front of the screws. Screw clockwise until
tight.
• Once done, replace the magnetic seal into initial position.
If you require any further assistance please contact customer services on
01455 555397.
BASIC OPERATION
It is recommended you install the Wine Cooler in a place where the
ambient temperature is between 23º-26ºC/72º-78ºF. If the ambient
temperature is outside this range, the performance of the unit may be
affected. Placing your unit in extreme cold or hot conditions may cause
interior temperatures to fluctuate and the range of 7º-18ºC/46º-65ºF
may not be reached.
• Temperature Range For Your Wine Cooler: 7-18°C/44-64°F
• Recommended Temperatures for Chilling Wine
Red wines: 14-18°C/57-65°F
White wines: 9-14°C/49-58°F
Rosé wines: 10-11°C/51-53°F
Sparkling wines: 5-9°C/40-49°F
4 HUSKY DUAL-ZONE SLIMLINE WINE COOLER
Hole 1
Hole 2
Hole 1
Screw 1
Hole 2
Handle
Magnetic Seal
Screw 2

HUSKY DUAL-ZONE SLIMLINE WINE COOLER 5
Setting the temperature controller
You can display the temperature in either Fahrenheit or Celsius by pressing
the °F/°C button.
You may change the temperature as you wish by pressing the UP or DOWN
buttons on the control panel. The set temperature will increase by 1ºF or 1ºC
for each depression of the UP button. The temperature will decrease by 1ºF
or 1ºC for each depression of the DOWN button.
NOTE: After you select your desired temperature the display will revert to
show the current temperature inside the cabinet, but it will gradually fall as
it reaches your set temperature.
If you store mostly red wines, the temperature will ideally be set between
14-18ºC (57-65ºF). If you store mostly white wines, the temperature will
ideally be set between 9-14ºC (49-58ºF).
NOTE: When you use the appliance for the first time or restart it after having
been turned off for a long time, there may be a few degrees difference
between the temperature you select and the one indicated on the LCD
readout. This is normal. Once the wine cooler has been running for a few
hours the display will stabilise.
The temperature displayed may deviate from your set temperature. The
internal temperature varies constantly due to the natural cooling cycle,
the door being opened, the introduction of new bottles, or air variations
around the position of the thermostat. This is not a sign of malfunction
or failure of the wine cooler.
Capacity
You may place up to 21 standard-sized 75cl bottles in this wine cooler. As
bottles differ widely in size the actual number of bottles may vary.
Interior light
The interior light may be turned ON or OFF by pushing the “Light” button.
Cleaning
CAUTION: Failure to unplug the Wine Cooler could result in electrical shock or
personal injury.
• Unplug the Wine Cooler, and remove all items including shelves.
• Wipe the inside surfaces with a damp cloth soaked in a solution of
two tablespoons of ordinary baking soda to a litre of water. Do not
use abrasive cleaners.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning area of
the controls, or any electrical parts.
• Wipe the outside cabinet with a solution of warm water and mild
liquid detergent. Rinse well and wipe dry with a clean soft cloth.