Hutt W8 User manual

HUTT Variable Frequency
Window Cleaning Robot

1Crawler Wheel
LED Indicators
Software
Debugging Port
Bottom Suction
Inlet
Cleaning PadMain Unit Remote Control Water Bottle
Safety Rope Power Adapter Plug User Manual
Nozzle
Water Tank
Power Button:

Remove the plug of the water tank, fill an appropriate amount
of pure water or glass cleaner , and then tighten the water tank
plug.
※The filling content must be non-corrosive liquid. For example:distilled
water,special glass water,pure water, etc. It is recommended to use
distilled water or special glass water for a better cleaning result.
※It is forbidden to fill corrosive liquid into the water tank.
Hold the machine in your hand and turn it over with the bottom
suction inlet upwards, start the machine，then press and hold
the power button, the crawler wheels will rotate slowly, then
use a wet tissue to wipe off the dirt on the crawler wheels.

※If there is too much dust on the surface of the glass, please wipe
clean an area the same size as the device before installing it.
（3）Make sure the machine has attached to the
glass,then release the machine and short-press the
button, and the machine starts to work.
（2）Hold the power button for more than 1s to start the
machine.
(1) It is recommended to spray some window cleaner to
the window before use.
1

2.Please use a dry cleaning pad. Children are not allowed to operate
this product.

8. Instructions for battery recycling
9. WEEE Information
10. Conformity
1. Remove all screws from the bottom, and open
the upper cover. 2. Unplug the battery socket and remove the battery.