HUUM UKU Guide
UKU GSM/ Wi-Fi/ Local
HEATER CONTROLCONSOLE 3–15
ELEKTRIKERISE JUHTSEADE 17–29
SÄHKÖKIUKAAN OHJAUSKESKUS 31–43
STEUERKONSOLE 45–58
59–73
BASTUAGGREGATETES STYRENHET 75–87
DISPOSITIVO DI COMANDO 89–101
103–115
117–129
CONSOLE DE COMMANDE POUR POÊLE 131–144
145–157
[email protected] www.huum.eu
3
UKU GSM/Wi-Fi/Local
HEATER CONTROLCONSOLE
Installation and User Instructions
NB! The electrical work described in this manual must be carried
The devices set contains:
• UKU control panel;
•
• thermal sensor;
• door sensor;
•
•
NB! Keep this operating manual near the device so that at any time
4
BEFORE INSTALLATION
Before installation read the operation manual thoroughly This
way
prevent
•
install the device.
• Installation and maintenance of the device is only allowed when it
is not under voltage.
• For unique problems that are not covered in the installation
•
authorisation.
• The manufacturer has the right to make improvements to the
device. The latest version of the operation manual can be found
• Make sure that the building’s cables from the main switchboard
switchboard
to the sauna. Install
separate
protection for the heater.
• It is recommended to connect the unit to the mains without an
earth-leakage circuit breaker.
• This product is intended to operate with equipment that meets
Symbols used in the installation manual
6
2
1
3
4
5
7
UKU control panel
Main controller
Door sensor
Temperature sensor
5
6
WARNING! Not following these instructions may lead to serious or fatal
CAUTION! Not following these instructions may lead to minor to semi-
NB! Also follow the special safety requirements given in the individual
INSTALLING UKU ELECTRICALCONTROL
DEVICE
• Before installation disconnect the electric heater from the power
supply in the switchboard.
• The control device 1must be installed outside the steam
manufacturer’s recommendations.
• If your main controller 2
supports the use of Wi-Fi or GSM
connec
tions
it must be
installed
where the appropriate
reception
is
available.
• The device must be installed in a dry place. The protection
•
CAUTION! The control device must be connected to the mains
NB! Measure the lengths of the cables and determine the locations of
NB! When connecting the the control device with a singel phase make
sure the fuse where the power is coming from has the necessary
7
Control panel UKU 1
With a wooden housing
• Remove
the
back
cover
of UKU
control
panel
to
it
to the
wall
.
•
control panel is at eye level.
•
•
wall. Secure it with screws from the sides.
With a plastic housing
•
the power cable with the cable screws of UKU
control
panel
.
•
•
• Replace the control knob to the control panel.
Main module 2
•
•
•
sensor and door switch through a cable gland to the enclosure
•
Door sensor 3
• T
•
• Secure the magnet to the door. It must allow the door to close
and pass directly by the doorpost.
• Secure the sensor to the doorpost so that when the door closes
the sensor and the magnet will be aligned. The maximum distance
door is closed.
8
Temperature sensor with overheating protection 4
•
•
•
•
•
Vaporiser 6
• A vaporiser is connected to outputs SLSN as shown in the
instructions.
CAUTION! When connecting the control console with an electrical
heater with vaporiser function ensure that the water tank is always
Connection of a lighting system
•
the control console.
•
•
7
9
Connecting the Wi-Fi controller to the network
•
controller doesn’t support Wi-Fi names and passwords longer
•
•
•
•
• You
can
continue
to enter the password after selecting a Wi-Fi network.
•
•
Connecting the GSM controller to the network
•
SIM card is activated. The SIM card and sauna will come online in
•
not want the mobile app after the free year you don’t have to pay
Payment is made by credit card in the mobile app.
•
UKU mobile app
The UKU Wi-Fi or GSM device can also be controlled by a smartphone
with a special mobile application in addition to the control panel. This
way you can put the sauna to work being far from home.
10
Download the HUUM application from the application page of your
• IOS – App Store;
• Android – Google Play;
• Web application - app.huum.eu
•
•
ID number and code of the sauna are on the sticker of the main
module.
•
working properly and your commands actually reach the sauna.
• An unlimited number of users can be connected to one sauna.
NB! In case the control console is not connected to the user account
in the mobile application, the sauna will not be connected with the
TESTING
NB!
WARNING!
• Check the power terminals of the circuit breaker and main
from the switchboard on by using the circuit breaker. The screen
• Check the door switch: close the steam room’s door. Turn the
control console on. Set the temperature. Turn the heating on.
seconds
must switch on
again
.
11
• Check the temperature sensor:
•
switchboard for quarter of minute and then on again. The
•
time – therefore it may take some time to reach the actual
temperature reading.
•
•
the temperature is achieved and maintained.
OPERATION MANUAL
•
• will appear above the
temperature value.
• If the symbol
connection has been turned on. The sauna will not be connected
to the network before it is connected to the app.
• The control console is connected to the network and ready for
appears on the status line.
• The signal strength of the cellular network is indicated by the
• The screen is always active during heating.
• Using the sauna from the control panel you can choose between
heating times of 3, 6 hours for private saunas, 12 hours for
semi-public saunas and 18 hours for public saunas from the
seings menu.
choose the heating period.
•
• The number displayed in the upper right corner of the screen is
12
the target temperature of the sauna. The current temperature is
displayed in the centre of the screen. Turn the knob to adjust the
temperature.
•
•
seconds.
•
•
With a simple heating
With a smart algorithm
gradually one by one before the target temperature is reached.
heating elements
•
appliance is connected to the LN LLoutputs for the selected time
Child lock
•
• The child lock will automatically turn on when the screen of the
•
quarter
to the left and back to the beginning to activate the screen
.
13
Timer
•
seconds.
•
Lighting
•
•
Vaporiser
•
•
• Heat intensity is displayed as an indicator in the lower left corner
Using the mobile app
• Set the desired temperature for the sauna and heating time (the
• Turn the sauna on.
• More details are available in the application’s instructions.
14
GENERAL
SAFETY INFORMATION FOR THE USER
• -
dition and safety. If the heat sensor with overheating protection
• For unique problems that are not covered in the installation
•
to alter or rebuild the device.
• The manufacturer has the right to make technical changes to the
device.
PURPOSEFULUSE
• Make sure that there are no objects on the heater. Even non-
combustible
items
resulting
•
Heating will not work with an open door.
•
• This device is not intended to be used by people with limited
supervised by a person responsible for their safety or they have
received instructions from such a person.
• Ensure that children do not play with the device.
•
sauna is not being used.
•
remove any items from the heater. Make sure steam room is safe
and close the door.
•
old devices into the household waste.
•
not intend to use the sauna for an extended period.
15
WARRANTY TERMS FOR HUUM EQUIPMENT
• The warranty only applies to the product that has been installed
and used in accordance with the manual.
•
considered as consumable parts.
• The warranty does not cover normal wear or improper use of the
product.
•
•
• damage or defects due to transport and or other actions not
controlled by manufacturer;
•
overloading the product;
• errors in the installation of the product due to non-
or safety requirements;
•
• product incompleteness;
• using together with products that are not compatible with
this device;
• when the product warranty period has expired.
17
UKU GSM/Wi-Fi/Local
ELEKTRIKERISE JUHTSEADE
Paigaldus- ja kasutusjuhend
NB! Käesolevas juhendis kirjeldatud elektritöid tohib teostada
• UKU kontrollpult;
•
• termoandur;
• ukseandur;
•
•
NB! Hoidke seda paigaldus- ja kasutusjuhendit seadme läheduses, et
saaksite igal hetkel ohutusnõuandeid ja seadme kasutamiseks olulist
18
ENNE PAIGALDAMIST
Lugege kasutusjuhend enne seadme paigaldamist põhjalikult
läbi, et kasutada seadme kõiki eeliseid ning vältida kahjustuste
tekkimist
• Seadet võib paigaldada ainult elektrik või samaväärse
•
ei ole pinge all.
•
pöörduge ohutuse tagamiseks oma tarnija poole.
• Seadet ei ole lubatud omavoliliselt muuta või ümber ehitada.
• Tootjal on õigus teha seadmele täiustusi. Kõige viimase
kasutusjuhendi versiooni leiate tootja kodulehelt (
www.huum.ee
•
asukohani oleks piisava ristlõikega. Vanema hoone korral pöörake
tähelepanu harutooside seisukorrale ning võimalusel vedage uus
juhe kilbist saunani. Paigaldage saunale eraldi voolukaitse.
• Soovitatav on seade ühendada vooluvõrku ilma rikkevoolu
kaitsmelülitita.
•
Joonis ja selle olulised detailid
6
2
1
3
4
5
7
UKU kontrollpult;
Peamoodul;
Ukseandur;
Termoandur;
19
20
Paigaldusjuhendis kasutatud ohutusnõuanded
NB!
PEAMOODULI PAIGALDAMINE
• Enne seadmete paigaldamist katkestage elektrikilbist elektri-
kerise toitevool.
• Kontrollpult 1
silmade kõrgusele ukse kõrvale või vastavalt leiliruumi tootja
soovitustele.
• Kui teie peamoodul 2
• Peamoodul tuleb paigaldada kuiva kohta. Seade vastab klassile
•
Peamoodul tuleb ühendada vooluvõrku püsivalt, kasutamata
NB! Mõõtke välja kaablite pikkused ja määrake kaablite ja seadmeosade
NB! Ühendades peamoodulit ühe faasiga kontrollige, et kaitse, mille
Other manuals for UKU
2
Table of contents
Languages:
Other HUUM Remote Control manuals
